期刊文献+

回火温度对Cr5钢组织和性能的影响 被引量:10

Influence of tempering temperature on microstructure and properties of Cr5 steel
原文传递
导出
摘要 通过扫描电镜和透射电镜观察了Cr5钢最终热处理后的碳化物形态分布、显微组织、断口形貌,在拉伸试验机、冲击试验机和洛式硬度计上对其力学性能进行测试。结果表明:最终热处理后组织中碳化物主要以M7C3为主,且尺寸相对细小,抗拉强度和硬度值随回火温度的升高而降低,伸长率有所提高;断口形貌由小准解理刻面逐渐向韧窝转变;回火温度为520℃时,抗拉强度、冲击功和硬度值分别为1490.24 MPa、211.8 J和51.7 HRC,与最终热处理前相比,性能得到明显改善(最终热处理前材料的抗拉强度、冲击功、硬度分别为1420 MPa、146 J、49 HRC)。 The microstructure( after different heat treatment),fracture morphology,phase of Cr5 steel were observed by means of scanning electron microscopy,transmission electron microscopy; the tensile strength,ductility and hardness were tested by Rockwell hardness tester,tensile and shock test machine respectively. The results show that the carbides of Cr5 steel are mainly M7C3 after final heattreated,the microstructure of Cr5 is improved dramatically. With the increase of tempering temperature,the tensile strength and the hardness decrease,the ductility increases. The morphology of the fracture is changed from small quasi cleavage facet to cavity. The materials have good comprehensive mechanical performance when the tempering temperature is about 520 ℃,the tensile strength is1490. 24 MPa,the impact energy is 211. 8 J and the hardness is 51. 7 HRC( the tensile strength,impact energy and hardness are1420 MPa,146 J,49 HRC before final heat-treated).
出处 《材料热处理学报》 EI CAS CSCD 北大核心 2015年第11期106-111,共6页 Transactions of Materials and Heat Treatment
基金 大型铸锻件生产共性技术研究(602009102013-1) 洛阳市科技支撑计划(1301057A)
关键词 Cr5钢 最终热处理 显微组织 碳化物 力学性能 Cr5 steel differential heat treatment microstructure carbides mechanical performance
  • 相关文献

参考文献10

二级参考文献71

共引文献106

同被引文献91

引证文献10

二级引证文献34

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部