期刊文献+

正交设计优化精制冠心颗粒的破壁提取工艺 被引量:2

Optimization of Breaking- Extraction Process for Jingzhi Guanxin Particle by Orthogonal Test
原文传递
导出
摘要 目的:针对传统回流提取易导致有效成分降解的弊端,研究破壁浸提精制冠心颗粒的最优工艺。方法:以芍药苷、阿魏酸与丹酚酸B含量的综合评分为评价指标,采用单因素结合正交试验考察溶媒用量、浸提次数、浸提温度与浸提时间对提取工艺的影响。结果:最佳提取工艺为药材粉碎至d0.5为14μm左右,加入8倍量水,在60℃条件下浸提3次,每次10 min。结论:该优选工艺稳定可行,能在提取环节显著增加有效成分的提取量,可代替传统的回流工艺。 Objective: To optimize the breaking- extraction process of Jingzhi Guanxin Particle,in order to overcome the disadvantage of effective components degradation. Methods: With composite score of the contents of paeoniflorin,ferulic acid and salvianolic acid B as indexes,single factor test and orthogonal test were applied to optimize extraction with the extraction time,times,temperature and the amount of water as factors. Results: The best extraction conditions were as follows: d 0. 5 of herbs were ground into about 14 μm,extracted 3 times in the condition of 60 ℃ with 8- fold amount of water,10 min for each time. Conclusion: This optimized extraction process was reasonable and feasible,and could significantly increase the extraction amount of effective components,expecting to replace the conventional reflow process.
出处 《辽宁中医杂志》 CAS 北大核心 2016年第3期566-569,共4页 Liaoning Journal of Traditional Chinese Medicine
基金 国家自然科学基金资助项目(81403115) 四川省重大产业技术创新专项项目(2011ZY00299)
关键词 精制冠元颗粒 正交设计 破壁提取 热敏性成分 orthogonal design breaking-extraction heat sensitive components
  • 相关文献

参考文献9

二级参考文献50

共引文献126

同被引文献78

引证文献2

二级引证文献27

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部