期刊文献+

滚筒式松散回潮机存在的问题及改进对策 被引量:6

Problems of Drum Loose Damping Machine and the Countermeasures
下载PDF
导出
摘要 针对滚筒式松散回潮机在生产中存在的烟叶松散程度不够、造碎大、指标均匀性偏低、能耗偏高等问题,进行了论证和分析,得出设备优化改进的理论推论,并在试验线松散回潮机上进行验证,具体是将试验设备模拟添加预松散设备,循环热风改为下进风方式,抽废气位置设在入料口上端。验证结果表明,使用改进后的设备松散率在99.60%以上;平均碎片量降低了39.60%,滚筒内部温度和出口水分的均匀性大幅提高,能更好地保证松散回潮烟叶质量指标的均匀性,降低能耗。 In the process of production, drum loose damping machine has the problems of not enough loose degree of tobacco leaf, low uni-formity of index, high energy consumption and so on.Demonstration and analysis showed the theoretical reasoning of improved facilities.And verification test was carried out on the loose damping machine.Test equipment was used to simulate the adding of pre-loose equipment, circu-lating hot air was changed into below inlet; the position of pumping waste gas located in the upper end of the entrance of materials.Results showed that the equipment loose rate after improvement reached more than 99.60%;the average amount of debris decreased by 39.60%.The uniformity of and outlet moisture and drum inner temperature greatly improved, which could better ensure the uniformity of quality index of loose damping tobacco leaves, and reduced the energy consumption.
出处 《安徽农业科学》 CAS 2016年第29期237-239,共3页 Journal of Anhui Agricultural Sciences
关键词 滚筒式松散回潮机 松散程度 循环热风 改进 Drum loose damping machine Loose degree Circulated hot water Improvement
  • 相关文献

参考文献1

二级参考文献6

  • 1金闻博 戴亚.烟草化学[M].北京:清华大学出版社,1993.53.
  • 2陈良元.卷烟加工工艺[M].郑州:河南科学技术出版社,1996..
  • 3国家烟草专卖局.卷烟工艺规范[M].北京:中央文献出版社,2003..
  • 4罗登山,姚光明,刘朝贤.我国卷烟加工工艺技术发展方向探讨[EB/OL].[2007-03-01].http://www.zsjy.com.cn/articles/200409011643.htm.
  • 5卷烟工艺编写组.卷烟工艺[M].北京:北京出版社,2000.
  • 6国家质量技术监督局.质量管理手册(下)[M].北京:中央教育出版社,1990.

共引文献8

同被引文献31

引证文献6

二级引证文献21

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部