期刊文献+

TC4钛合金与多层TiN/Ti涂层的砂尘冲蚀损伤试验 被引量:12

Sand erosion damage test on TC4 titanium alloy and TiN/Ti multilayer coating
原文传递
导出
摘要 建了砂尘冲蚀试验系统,采用粒子成像测速方法获得了气体压力和砂尘速度之间的关系,并在砂尘质量浓度为28.91g/m3,速度为80m/s,冲蚀角度为30°的条件下,对TC4钛合金和多层TiN/Ti涂层进行了冲蚀试验.结果表明:TC4钛合金抗冲蚀损伤能力较差,平均质量损失率达0.7mg/min.多层TiN/Ti涂层可承受砂尘冲蚀200min以上,且TiN/Ti调制比为1∶3涂层的抗冲蚀能力优于调制比为1∶1的涂层.砂尘粒子垂直冲击速度分量引起的微区剥落是涂层冲蚀损伤的主要原因,增加多层涂层韧性是提高其抗冲蚀性能的关键. A sand erosion test system was set up. The relationship between gas pressure and sand particle velocity was obtained by using particle image velocimetry method, and the erosion performance of TC4 titanium alloy and TiN/Ti multilayer coating was tested at the condition of sand concentration 28.91 g/m^3 , sand particle velocity 80 m/s, and impact angle 30°. The results show that, the anti-erosion performance of TC4 titanium alloy is poor with average mass loss rate about 0.7 mg/min. TiN/Ti multilayer coatings can withstand sand erosion more than 200 minutes. TiN/Ti multilayer coating with modulation ratio of 1 - 3 is superior to that with the modulation ratio of 1 : 1 on the anti-erosion performance. Microspalling caused by the vertical impact component of sand particle velocity is the main reason for erosion damage of coating. Therefore, the key to improve anti-erosion performance of multilayer coating is enhancing the toughness.
出处 《航空动力学报》 EI CAS CSCD 北大核心 2016年第9期2218-2225,共8页 Journal of Aerospace Power
基金 国家自然科学基金(51405506) 陕西省科学技术研究发展计划(2014K08-26) 陕西省科技统筹创新工程计划(2015KTCQ01-72)
关键词 钛合金 砂尘冲蚀 损伤 多层TiN/Ti涂层 质量损失率 titanium alloy sand erosion damage TiN/Ti multilayer coating mass loss rate
  • 相关文献

参考文献9

二级参考文献94

共引文献137

同被引文献150

引证文献12

二级引证文献49

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部