摘要
为了研究Al／Ni反应多层膜在爆炸箔起爆系统上应用的可行性，采用磁控溅射法制备了相同厚度的Cu和Al／Ni多层膜桥箔，利用SU-8光刻胶制备一定厚度的加速膛，研究了两类桥箔在相同放电回路中的沉积能量和驱动飞片的平均速度。结果表明：在储能电容电压为1306V的放电回路中，Al／Ni多层膜的沉积能量为0．1205～0．1274J，相比Cu箔提高了近1倍。在电压为1900V时，多层膜沉积能量比Cu箔提升了18％～58％；多层膜驱动的飞片平均速度高于叫占驱动飞片约10％。因此，Al／Ni反应多层膜能降低爆炸箔起爆系统的起爆阈值，提高其冲击起爆的可靠性。
To investigate the influence of Al/Ni reactive multilayer foils on the exploding foils initiator, Cu and Al/Ni exploding foils with the same bridge size were fabricated and tested at the identical discharge circuit. SU-8 photoresist was employed to prepare the barrel. Results showed the energy deposition of AI/Ni foil was between 0.120 5 - 0.127 4 J, which was nearly twice than the value of Cu foil, with a operating voltage of 1 306 V. Compared with Cu foil, 18% - 58 % increase of energy deposition was found when the capacitor was initially charged to 1 900 V. Meanwhile, the average velocity of flyer driven by multilayer foils was higher than that by Cu foil about 10%.It can be concluded that Al/Ni exploding foil is able to enhance the reliability of the initiator and reduce its initiation threshold.
出处
《火工品》
CAS
CSCD
北大核心
2016年第5期1-5,共5页
Initiators & Pyrotechnics
基金
火工品安全性可靠性技术国防科技重点实验室基金资助(批准号:9140C37050C37174)
关键词
含能材料
Al/Ni反应多层膜
爆炸箔起爆系统
沉积能量
Energetic material
Al/Ni reactive multilayer foils
Exploding foil initiator
Energy deposition
