摘要
普遍使用的代数距离最小的最小二乘(LS)椭圆拟合算法简单、易实现,但对样本点无选择,导致拟合结果易受误差点影响,拟合不准确。针对此特性,提出了一种基于莱特准则的椭圆拟合优化算法。首先,由代数距离最小的LS法对待拟合曲线进行椭圆拟合;其次,将待拟合曲线上的点与LS法拟合的椭圆的代数距离作为样本点集,在验证该样本点集服从正态分布的情况下,采用莱特准则,将样本点中值大于|3σ|的点判定为野值并剔除,进行多次拟合,直至样本点中无野值;最后,得到椭圆最优拟合结果。仿真实验结果表明,优化算法的拟合误差在1.0%以下,相比同条件下的LS法,其拟合精度至少提高2个百分点。优化算法的仿真结果与其在香烟圆度在线检测中的实际应用验证了此算法的有效性。
The commonly used Least Square （LS） ellipse fitting algorithm based on minimum algebraic distance is simple and easy to implement, but it has no choice to the sample points, which leads to the fitting results are easily inaccurate due to the error points. According to this case, an improved ellipse fitting algorithm based on Letts criterion was proposed to overcome the shortage of LS algorithm. Firstly, the ellipse was fitted from the fitting curve by using the LS ellipse fitting algorithm based on minimum algebraic distance. Then, the algebraic distance of ellipse fitted by LS algorithm from the point distance on the fitting curve was set as the fitting point set. After the point set was verified to be normal distribution, the points which were greater than 13σI were determined to be outliers and eliminated by using Letts criterion. Then the steps above were repeated until all points were within the scope of [ - 3σ, 3σ]. Finally, the best fitting ellipse was obtained. The simulation experiment results show that the fitting error of the improved algorithm based on Letts criterion is within 1.0%, and its fitting accuracy is improved by at least 2 percentage points compared with the LS algorithm under the same condition. The simulation result and the practical application in roundness measurement of cigarette verify the effectiveness of the improved algorithm.
出处
《计算机应用》
CSCD
北大核心
2017年第1期273-277,共5页
journal of Computer Applications
关键词
莱特准则
椭圆拟合
最小二乘法
圆度检测
视觉检测系统
Letts criterion
ellipse fitting
Least Square（LS） algorithm
roundness measurement
vision detectionsystem
