摘要
通过等温压缩实验、光学显微镜与透射电镜研究了变形温度300~450℃、应变速率0.01~1s-1、真应变0.36~1.2范围内变形条件对5083铝合金热变形组织演变的影响。结果表明:升高热变形温度或降低应变速率均可促进5083铝合金的动态再结晶发生,使变形后5083铝合金位错密度降低,再结晶晶粒尺寸增大;随着应变量的增加,变形后合金的位错密度降低,动态再结晶程度增大。根据唯象理论的指数模型,利用线性回归方法建立了5083铝合金动态再结晶晶粒度模型,模型计算值与实测值吻合良好,平均相对误差仅为4.6%。
The influences of hot deformation condition upon the microstructure of 5083 aluminum alloy during compressing in the temperature range of 300—450℃,the strain rate range of 0.01—1s-1 and the strain range of 0.36—1.2were studied by means of isothermal compressive deformation,optical microscopy and transmission electron microscopy.The results show that both the increase of deformation temperature and the decrease of strain rate benefit dynamic recrystallization,which results in the decrease of the dislocation density of 5083 aluminum alloy and the increase of the recrystallization grains size.With the increase of strain of 5083 aluminum alloy,the dislocation density decreases and the volume fraction of dynamic recrystallization increases.According to the exponential model of phenomenological theory and the linear regression method,the dynamic recrystallization grain size model of 5083 aluminum alloy during the thermoplastic deformation was constructed,and the model calculation value coincided well with the experimental data,as the average relative error was only 4.6%.
作者
戴青松
欧世声
邓运来
付平
张佳琪
DAI Qingsong OU Shisheng DENG Yunlai FU Ping ZHANG Jiaqi(School of Materials Science and Engineering, Central South University, Changsha 410083 Guangxi Liuzhou Yinhai Aluminum Co. , Ltd. , Liuzhou 545006 Light Alloy Research Institute, Central South University, Changsha 410083)
出处
《材料导报》
EI
CAS
CSCD
北大核心
2017年第14期143-146,152,共5页
Materials Reports
基金
广西科学研究与技术开发计划课题(桂科重1598001-2
桂科重14122001-5)
关键词
5083铝合金
热变形条件
微观组织
动态再结晶
晶粒度模型
5083 aluminum alloy
hot deformation condition
microstructure
dynamic recrystallization
grain size model
