摘要
本文设计了1种新型沟槽结构充液式冷辐射板,并开展了辐射板供冷性能的实验研究。实验结果表明:沟槽结构及内部充液设计,可强化冷水与辐射板表面间的换热,显著提高辐射板表面温度分布的均匀性,消除局部低温,从而实现较好的热舒适性。在实验小室室温为27~34℃,冷水供水温度为15~17℃,供水流量为0.1~0.2 L/s时,本辐射板单位面积供冷量可达260~720 W/m2。实验工况下辐射板表面温度较为均匀,最大温差为2.9℃,辐射板下部垂直方向上温度梯度小于3℃/m。
A new type of grooved cold radiant panel filled with liquid is designed in this paper. The experimental study on the cooling performance of the radiant panel has been carried out and the research results show that the groove structure and liquid filled inside the channel can enhance the heat transfer between the cold water and the outer surface,significantly improve the uniformity of the surface temperature of the radiant panel,and eliminate the local low temperature. Therefore,the radiant panel has high thermal comfort in practical application. When the temperature of the chamber is 27 ～34 ℃,the water supply temperature will be 15 ～17 ℃ and the water supply flow rate will be 0. 1 ～ 0. 2 L/s,and the cooling capacity per unit area can reach 260 ～ 720 W/m2. The radiation wall temperature distribution is uniform,with the maximum temperature difference being 2. 9 ℃. The temperature gradient in the vertical direction below the radiant panel is lower than 3 ℃/m.
作者
韩志涛
陈栋
廖维
吕国荃
程晓雪
HAN Zhitao;CHEN Dong;LIAO Wei;LYU Guoquan;CHENG Xiaoxue(School of Civil Engineering,Northeast Forestry University,Harbin,Heilongjiang Province,China 150040)
出处
《建筑科学》
CSCD
北大核心
2018年第8期51-56,共6页
Building Science
关键词
冷辐射板
供冷性能
沟槽结构
温度分布
实验
radiant cooling panel
cooling performance
grooved structure
temperature distribution
experiment
