期刊文献+

烟丝含签率在线检测设备的研制和应用 被引量:3

Development and application of device for online detection of sliver content in cut tobacco
下载PDF
导出
摘要 为解决人工检测烟丝含签率效率低、耗时长、结果差异大等问题,采用多级流化原理研制了一种烟丝含签率在线检测设备。该设备主要由流化室、吸丝管、烟丝收集室、烟尘烟末收集室等部分组成,流化室采用截面大、小、大、小、大、小交替变化的气流通道实现梗签和烟丝的完全分离。以广州卷烟厂某牌号烟丝为对象进行测试,结果表明:烟丝含签率实测值与理论值绝对误差在0.007 9%~0.188 1%之间,标准偏差在0.295 0%~0.862 3%之间,在线检测设备的准确度和精密度均可满足生产要求;最佳取样量和取样次数分别为150 g和30次;烟丝含签率在3%以上时,烟丝含签率增大对检测结果的绝对误差、相对误差、标准偏差无明显影响,在线检测设备对不同烟丝含签率的检测效果良好。该系统可为制丝线快速、准确检测烟丝含签率提供技术支持。 In order to detect sliver content in cut tobacco rapidly and accurately, an online detection device was developed on the basis of multistage fluidizing principle. The device is mainly composed of a fluidizing chamber, cut tobacco suction pipes, a cut tobacco collecting box and a dust collecting box. The cross-sectional area of the fluidizing chamber varies alternately between two set values along the air passage to separate slivers from cut tobacco thoroughly. The cut tobacco of a certain cigarette brand was tested in Guangzhou Cigarette Factory, the results showed that the absolute errors between the measured value and theoretical value of sliver content in cut tobacco ranged from 0.007 9% to 0.188 1%, the standard deviations ranged from 0.295 0% to 0.862 3%; both the accuracy and precision met production requirements, the preferable sampling volume was 150 g, and the preferable number of repeated tests was 30. When the sliver content in cut tobacco is higher than 3%, the increase of sliver content does not influence the absolute error, relative error and standard deviation of test results significantly. This device provides a technical support for rapidly and accurately detecting the sliver content in cut tobacco during primary processing.
作者 江威 卢浥良 曾静 张国智 冯志斌 谢海 戴石良 张保平 邝颖琪 李娟娟 孙兆东 孔臻 李斌 冯所阳 刘栋 JIANG Wei1, LU Yiliang1, ZENG Jing1, ZHANG Guozhi2, FENG Zhibin1, XIE Hai3, DAI Shiliang3, ZHANG Baoping3, KUANG Yingqi1, LI Juanjuan1, SUN Zhaodong1, KONG Zhen4, LI Bin4, FENG Suoyang2, LIU Dong1(1. Technology Center, China Tobacco Guangdong Industrial Co., Ltd., Guangzhou 510385, China;2. Guangzhou Cigarette Factory, China Tobacco Guangdong Industrial Co., Ltd., Guangzhou 510385, China;3. Hunan Sunny Technology Engineering Co., Ltd., Hengyang 421001, Hunan, China;4. Zhengzhou Tobacco Research Institute of CNTC, Zhengzhou 450001, China)
出处 《烟草科技》 EI CAS CSCD 北大核心 2018年第9期91-97,共7页 Tobacco Science & Technology
基金 广东中烟工业有限责任公司科技项目"提高双喜高档卷烟烟支烟丝纯度的技术研究"(粤烟工[2014]科字第001号)
关键词 制丝线 烟丝含签率 在线检测 准确度 取样量 取样次数 Tobacco primary processing line Sliver content in cut tobacco Online detection Accuracy Sampling volume Number of repeated tests
  • 相关文献

参考文献11

二级参考文献101

  • 1易浩,黄振军,陈刚,谭新良.取消制叶丝工序中VAS的可行性[J].烟草科技,2005,38(10):22-24. 被引量:7
  • 2田耀华.制药工业粉体混合设备选用探讨[J].机电信息,2006(17):14-19. 被引量:8
  • 3李晓,熊安言.FX6型就地风选器在梗签风选中的应用[J].烟草科技,2006,39(8):9-11. 被引量:19
  • 4张元培.现代制粉工艺讲义(内部教材)[M].北京:商业部制粉烘焙培训中心,1990..
  • 5-.华中农业大学气流式清选机(实用新型专利)[J].中国专利:ZL87203919,1987,.
  • 6赵学笃.谷粒空气动力学牡 性的实验研究[J].农业机械学报,1979,(4):42-50.
  • 7Wilhelm RH and Kwank M. Fluidizafion of solid particles. Chem Eng Prog, 1948, 44(3) :201 -218.
  • 8Brown GG. Unit Operations, Chapter 20, Ftuidization of Solids. Wiley, 1950:269 - 274.
  • 9Hoover HC and Hoover LH. Agricola Georgius. De Be Metallica. New York: Dover Publication Inc, 1950.
  • 10Song YX, Tian Gong and Kai Wu. 1637. 100 Famous Books from Ancient Times Vol. 6. Xia YQ and Guo C. Beijing: Blue Sky Press, 1998.

共引文献86

同被引文献39

引证文献3

二级引证文献3

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部