期刊文献+

对折式微通道蒸发器固定与安装方式研究

Analysis and Discussion about Folded Micro-channel Evaporators' Mounting and Installation
下载PDF
导出
摘要 针对折式微通道蒸发器的固定设计进行了分析与研究,指出对折式微通道蒸发器固定和安装方面的问题与解决方案。针对蒸发器出现的错位和上窄下宽的问题,结合微通道蒸发器质量轻的特点,通过长度方向安装组合安装板,高度方向以挡风设计为主的方式进行固定和安装。经过多轮的试装与生产验证,方案成功应用于新一代产品中。 This paper analyzes the fixed design of the folded microchannel evaporator and points out the problems and solutions for the fixing and installation of the folded microchannel evaporator. The problem of misalignment occurring with the evaporator and the lower is wider than the upper width. Combined with the light weight of the microchannel evaporator, the combined mounting plate is mounted along the length;it is fixed in the height direction for the windproof design. After several rounds of trial installation and production verification, the solution is successfully applied to a new generation of products.
作者 徐敏 XU Min(Ingersoll Rand Engineering & Technology Center-Asia Pacific, Taicang 215400, China)
出处 《机械工程师》 2019年第3期149-150,154,共3页 Mechanical Engineer
关键词 对折工艺 错位 公差 收缩量 安装板 double folding process misalignment tolerance shrinkage mounting plate
  • 相关文献

参考文献1

二级参考文献19

  • 1Andrew Keogh. Micro-channel heat exchanger [J]. IEA Heat Pumps Newsletter, 2007,25 (3) : 15-17.
  • 2K Andrew. Mircochannel heat exchangers[J].IEA Heat Pump Centre Newsletter, 2007, 25 (3):15-17.
  • 3P Kennet, C M Claudi, N Stefan, et al. The advantage of brazed aluminum heat exchanger applied in HVAC 8~ R field[C] // The SAPA Shanghai 2008 Technical seminar. Shanghai, 2008.
  • 4Cho H, Cho K. Mass Flow Rate Distribution and Phase Separation of R-22 in Multi-Microchannel Tubes under Adiabatic Condition [J]. Microscale Thermophysical Engineering, 2004,8(2) : 129-139.
  • 5Sa Y C, Jang D Y, Ko Oh S K. Flow Maldistribution of Flat Tube Evaporator [C]//The 4th international Symposium on HVAC. Beijing, 2003.
  • 6Vishwomath Subramaniam. Design of air-cooled microchannel condensers for real-distributed air flow conditions[D]. Georgia institute of technology, 2004.
  • 7T kvlkarnic, C W Bullard. Design tradeoffs in microchannel heat exchanger[C] // University of Illinois at Urbana Champaign. ARCR TR-208, 2003.
  • 8S Jain, CW Bullard. Optimization of heat exchanger design parameters for hydrocarbon refrigerant system [C] // University of Illinois at Urhana Champaign. ARCR TR-233, 2003.
  • 9C B Sobhan, S V Garimella. A comparative analysis of studies on heat transfer and fluid flow in micro- channles[J]. Microscale Thermophys Eng, 2001 (5) 293-311.
  • 10K Man-Hoe, B W Clark. Air-side performance of brazed aluminum heat exchangers under dehumidif- ying conditions[J]. International Journal of Refrigeration, 2002 (25):924-934.

共引文献34

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部