期刊文献+

电镀Ni-P-Ti3C2Tx合金镀层的制备以及性能研究 被引量:2

Preparation and Properties of Ni-P-Ti3C2Tx Electrodeposited Plating
下载PDF
导出
摘要 目的提高Ni-P合金镀层的硬度及腐蚀防护性能。方法块体Ti3AlC2颗粒经过氢氟酸的刻蚀作用得到二维层状结构的Ti3C2Tx材料,并通过电沉积技术将其掺杂到Ni-P合金镀层中,从而制备出Ni-P-Ti3C2Tx复合合金镀层,研究复合合金镀层的成分、表面形貌、表面接触角和硬度,并结合动电位极化曲线以及尼奎斯特阻抗图,分析Ti3C2Tx颗粒掺杂对Ni-P合金镀层性能的影响。结果通过深入研究复合合金镀层的性能,发现随着Ti3C2Tx颗粒掺杂量的增加,Ni-P-Ti3C2Tx合金镀层的表面粗糙程度不断增加,这可能是由于导电的Ti3C2Tx颗粒使得合金镀层的树枝状结晶增加,而且合金镀层的表面接触角增大,对于提高合金镀层的腐蚀防护性能有很大的促进作用。由于Ti3C2Tx颗粒的掺杂,合金镀层的显微硬度得到了提高,这主要是依靠于弥散增韧的作用以及有限的晶界。Ni-P-Ti3C2Tx合金镀层的腐蚀防护性能随着Ti3C2Tx颗粒掺杂量的增加,出现了先增加后减小的趋势。结论Ti3C2Tx颗粒的掺杂对提高Ni-P合金镀层的硬度以及腐蚀防护性能有一定的作用。 The work aims to improve the microhardness and corrosion protection of Ni-P coatings.The block Ti3AlC2 particles were disposed with 40%hydrofluoric acid to obtain Ti3C2Tx particles with the two-dimensional layered structure and then Ti3C2Tx particles were added into electroplating bath to prepare Ni-P-Ti3C2Tx composite coatings by electrodeposited technology.The composition,surface morphology,surface contact angle and microhardness of Ni-P-Ti3C2Tx composite coatings were studied,and the effect of Ti3C2Tx particles on the properties of Ni-P coatings was analyzed by combining the dynamic potential polarization curves and Nyquist impedance diagrams.Through in-depth analysis of the performance of Ni-P-Ti3C2Tx composite coatings,the surface roughness of Ni-P-Ti3C2Tx composite coatings increased unceasingly with the increasing doped amount of Ti3C2Tx particles.This was because that the conductive Ti3C2Tx particles increased the dendritic crystal and the surface contact angle of Ni-P-Ti3C2Tx composite coatings grew,thus playing a great role in improving the corrosion protection performance of Ni-P-Ti3C2Tx composite coatings.Moreover,the microhardness of Ni-P-Ti3C2Tx composite coatings improved with the doped Ti3C2Tx particles,mainly depending on the effect of dispersion toughening and limited grain boundaries.The corrosion protection performance of Ni-P-Ti3C2Tx composite coatings increased at first and then decreased with the increasing doped amount of Ti3C2Tx particles.Doped Ti3C2Tx particles can improve the microhardness and corrosion protection of Ni-P composite coatings.
作者 杜英超 仉小猛 魏连启 王永良 于博 叶树峰 DU Ying-chao;ZHANG Xiao-meng;WEI Lian-qi;WANG Tong-liang;YU Bo;YE Shu-feng(State Key Laboratory of Multiphase Complex Systems,Institute of Process Engineering,Chinese Academy of Sciences,Beijing 100190,China;School of Chemical Engineering,University of Chinese Academy of Sciences,Beying 100049,China)
出处 《表面技术》 EI CAS CSCD 北大核心 2019年第12期87-93,共7页 Surface Technology
基金 国家重点研究计划(2017YFC0703205)~~
关键词 Ti3C2Tx颗粒 电沉积 Ni-P-Ti3C2Tx合金镀层 硬度 耐腐蚀 Ti3C2Tx particles electrodeposited technology Ni-P-Ti3C2Tx composite coatings microhardness wear resistance
  • 相关文献

参考文献5

二级参考文献67

  • 1梅炳初,徐学文,朱教群,刘俊.Ti_3AlC_2的制备与微观结构[J].硅酸盐学报,2004,32(7):897-900. 被引量:12
  • 2梅炳初,徐学文,朱教群,刘俊.热压烧结Ti_3AlC_2材料的制备、结构与性能研究[J].稀有金属材料与工程,2005,34(5):684-687. 被引量:18
  • 3王柏春,朱永伟,许向阳,翟海军.Ni-P基化学复合镀的研究与应用[J].材料导报,2005,19(6):71-74. 被引量:17
  • 4黄新民,邓宗钢.化学复合镀工艺研究[J].表面技术,1996,25(4):9-11. 被引量:5
  • 5ZHAI H X,HUANG Z Y,AI M X,et al.Tribophysics properties ofbulk polycrystalline[J].J Am Ceram Soc,2005,88(11):3270–3274.
  • 6PIETZKA M A,SCHUSTER J.C.Summary of constitutional data onthe aluminum-carbon-titanium system[J].J Phase Equilibria,1994,15(4):392–400.
  • 7MYHRA S,CROSSLEY J A A,BARSOUM M W.Crystal-chemistryof the Ti3AlC2 and Ti4AlN3 layered carbide/nitride phases characteriza-tion by XPS[J].J Phase Chem Solid,2001,62:811–817.
  • 8WANG X H,ZHOU Y C.Mirostructure and properities of Ti3A1C2prepared by the solid-liquid reaction synthesis and simultaneous insituhot pressing process[J].Acta Mater,2000,50:3141–3149.
  • 9王盘鑫.粉末治金学[M].北京:治金工业出版社,2005.
  • 10WANG X H,ZHOU Y C.Stability and selective oxidation of alumi-num in nano-laminate Ti3AlC2 upon heating in argon[J].Chem Mater,2003,15(19):3716–3720.

共引文献56

同被引文献35

引证文献2

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部