期刊文献+

用于钢板厚度测量的常用电磁超声线圈特性研究 被引量:11

Study on characteristic of the common electromagnetic acoustic coils for thickness measurement of steel plates
下载PDF
导出
摘要 为解决电磁超声检测信噪比低,为电磁超声线圈设计提供参考依据,该文针对常用的测厚电磁超声线圈开展一系列实验研究。首先对比螺旋线圈、矩形线圈、吕形线圈和蝶形线圈4种线圈结构的测厚反射回波信噪比,实验对象采用阶梯型钢板,结果发现螺旋线圈对于厚板测厚效果最佳,信噪比平均值达到14 dB以上。然后研究上述线圈的幅频特性,实验结果表明激励频率为1.8 MHz时,所有线圈的信噪比达到10 dB以上。最后通过线圈作用范围实验,得出不同类型线圈的主要作用区域也不同的结论。 In order to solve the low signal-to-noise ratio of electromagnetic acoustic testing and provide a reference for the design of electromagnetic ultrasonic coils,a series of experimental researches are carried out on commonly used electromagnetic acoustic coils for thickness measurement.Firstly,by comparing the thickness and reflection echo signal-to-noise ratios of the four coil structures of spiral coil,square coil,doublerectangular coil and butterfly coil,the experimental object uses a stepped steel plate.The results shows that the average signal-to-noise ratio is above 14 dB.Next,the amplitude-frequency characteristics of the above coils are studied.The experimental results show that when the excitation frequency is 1.8 MHz,the signal-to-noise ratio of all the coils is above 10 dB.Finally,through the experiment of the range of the coil,it is concluded that the main areas of action of different types of coils are also different.
作者 徐煦源 涂君 张旭 宋小春 XU Xuyuan;TU Jun;ZHANG Xu;SONG Xiaochun(School of Mechanical Engineering,Hubei University of Technology,Wuhan 430068,China)
出处 《中国测试》 CAS 北大核心 2020年第4期143-147,共5页 China Measurement & Test
基金 国家自然科学基金(51707058,51807052) 湖北省重大技术创新项目(2018AAA034)。
关键词 电磁超声 测厚 线圈特性 实验研究 electromagnetic acoustic thickness measurement coil characteristics experimental study
  • 相关文献

参考文献8

二级参考文献74

  • 1陈阳生,林友仰.永磁电机气隙磁密的分析计算[J].中国电机工程学报,1994,14(5):17-26. 被引量:45
  • 2张广纯.电磁声(EMA)检测技术的研究、开发与工程化[J].应用声学,1995,14(2):1-6. 被引量:13
  • 3王淑娟,康磊,赵再新,翟国富.电磁超声换能器的研究进展综述[J].仪表技术与传感器,2006(5):47-50. 被引量:50
  • 4康磊,王淑娟,翟国富.用于电磁超声检测系统的宽带匹配电路的设计[J].仪表技术与传感器,2007(4):50-52. 被引量:12
  • 5MIRKHANI K,CHAGGARES C,MASTERSON C,et al.Optimal design of EMAT transmitters[J].NDT & E International,2004,37(3):181-193.
  • 6JIAN X,DIXON S,EDWARDS R,et al.Effect on ultrasonic generation of a backplate in electromagnetic acoustic transducer[J].Journal of Applied Physics,2007,102:0249091-0249096.
  • 7HIRAO M,OGI H.EMATS for science and industry:Non-contacting ultrasonic measurements[M].Boston:Kluwer Academic Publishers,2003.
  • 8HIRAO M,OGI H,YASUI H.Contactless measurement of bolt axial stress using a shear-wave electromagnetic acoustic transducer[J].NDT & E International,2001,34(3):179-183.
  • 9KALTENBACHER Computer optimization of electromagnetic acoustic transducers[J].Ultrasonics Symposium,1998,1(2):1029-1034.
  • 10MAXFIELD B W,LINZER M.Design of permanent magnet electromagnetic acoustic-wave transducers (EMATS)[J].Ultrasonics Symposium Proceedings,IEEE Cat.,1976:22-25.

共引文献80

同被引文献61

引证文献11

二级引证文献12

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部