期刊文献+

深孔圆环成形缺陷分析及改进方案 被引量:3

Forming defect analysis and improvement scheme of deep hole ring
原文传递
导出
摘要 以某深孔圆环为研究对象,针对其成形过程凸模磨损的问题,采用有限元软件DEFORM-3D对其成形进行模拟,从金属流线、成形载荷、应力分布等多方面进行分析。结果表明,初始工艺能够完成制件成形,但成形过程中局部材料受到较大的挤压应力,挤内孔成形过程中的局部金属流线较乱、流动阻力较大,导致成形载荷上升、模具磨损加剧。引入锥面成形工位,将初始工艺中的挤内孔工位拆分为锥面成形和圆角填充两个工位。通过模拟和实际试模,验证了改进方案的可行性,成形后的制件表面无折叠、裂纹、刮伤等缺陷,模具寿命得到明显提高,为实际生产提供了指导。 Taking a deep hole ring as object,to solve the wear problem of punch during forming process,the finite element software DEFORM-3 D was used to simulate its forming process.The metal flow line,forming load,distribution of stress,etc were analyzed.The results show that the initial process can completely finish the forming of parts.But,the local materials is subject to larger extrusion stress during the forming process,the local metal flow line is disorderly and the flow resistance is large during the extrusion inner hole forming process,which leads to the increasing of forming load and mold wear.By introducing a taper forming station,the original process was split into a taper forming station and a fillet filling station.Through simulation and actual trial,the feasibility of the improved scheme was verified.There are no defects such as fold,crack and scratch on the surface of parts formed.The service life of mold is significantly improved,which provides guidance for the actual production.
作者 沈步楼 沈禹 Shen Bulou;Shen Yu(Professional 2,Yancheng Traffic Technical College,Yancheng 224000,China;Faculty of Science,National University of Singapore,Singapore 119076,Singapore)
出处 《锻压技术》 CAS CSCD 北大核心 2020年第7期29-35,共7页 Forging & Stamping Technology
关键词 深冲 闭式模锻 模具磨损 深孔圆环 锥面成形 deep drawing closed-die forging die wear deep lole ring taper forming
  • 相关文献

参考文献8

二级参考文献49

共引文献30

同被引文献26

引证文献3

二级引证文献9

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部