期刊文献+

基于FT1500A多输入中断信号系统研究与设计 被引量:1

Study and Design of FT1500A Multi-input Interrupt Signal System
下载PDF
导出
摘要 针对FT1500A处理器GPIO数量较少又没有专用扩展芯片,讨论了三种替代方案,并设计了一种基于国产MCU GD32F403VC实现支持50路外部中断输入系统方案。FT1500A处理器通过串口与GD32F403VC连接,并通过串口配置GD32F403VC GPIO检测中断模式,外部中断信号触发GD32F403VC GPIO,GD32F403VC再通过串口将相应中断信号发送至处理器。最后对比测试了实验效果,验证MCU方案可行性与可靠性。 This paper discusses three alternative schemes,and designs a scheme based on the domestic MCU GD32 F403 VC to support the 50 external interrupt input system to solve the problem that the number of FT1500 A processor GPIO is few and none of the special extended chip.FT1500 A processor is connected to GD32 F403 VC through serial port,and GD32 F403 VC GPIO is configured to detect interrupt mode through serial port.GD32 F403 VC GPIO is triggered by external interrupt signal,and sends corresponding interrupt signal to the processor through serial port.Finally,the experimental results are compared to verify the feasibility and reliability of the MCU scheme.
出处 《工业控制计算机》 2021年第2期38-40,共3页 Industrial Control Computer
关键词 FT1500A GD32 串口 GPIO FT1500A GD32 UART GPIO
  • 相关文献

参考文献2

二级参考文献3

共引文献11

同被引文献18

引证文献1

二级引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部