摘要
针对形状特殊的压力容器受压元件设计,当无法按照压力容器设计第一强度理论的标准计算式进行设计时,若按照验证性爆破试验设计方法,设计周期长、试错成本高。给出了另外一种设计方法,即采用SolidWorks Simulation软件,将压力容器受压元件进行三维建模、应力分析和结果评定,并给出了优化设计的结果,最后结论表明该方法可以满足工程应用要求。
When the pressure components of pressure vessel with special shape can not be designed according to the standard formula of the first strength theory of pressure vessel design,the design cycle will be long and the cost of trial and error will be high if the design method of confirmatory blasting test is used.This paper presents another design method,that is,using SolidWorks simulation software to carry out three-dimensional modeling,stress analysis and result evaluation of pressure components of pressure vessel,and gives the results of optimization design.The final conclusion shows that this method can meet the requirements of engineering application.
作者
栗伟
孙超
李万刚
Li Wei;Sun Chao;Li Wangang(Shandong Grad Group Co.,Ltd,Dezhou,253000;Shangshi environment(Dezhou)sewage treatment Co.,Ltd,Dezhou,253000)
出处
《制冷与空调（四川）》
2021年第5期695-698,770,共5页
Refrigeration and Air Conditioning
