摘要
针对汽车前保险杠横梁零件在冲压成形过程中可能出现的开裂、起皱、回弹等缺陷,采用Dynaform软件分析产生缺陷的影响因素,如成形方式、压边力、摩擦系数、冲压速度等,分别采取措施对成形方式、工艺参数、回弹等进行优化,模拟结果显示,优化后的零件成形效果较好,回弹补偿后得到的零件满足公差要求,从而验证了优化方法的可行性和回弹控制措施的有效性。
The defects such as crack,wrinkle and springback may occur in the forming process of the automobile front bumper cross beam.The influence factors of defects,such as forming methods,blank holder force,friction coefficient,stamping speed,etc.were analyzed by Dynaform software.It was taken measures respectively to optimize the forming method,process parameters and springback.The simulation results showed that the part forming effect was better after optimizing,and the part obtained after springback compensation met the tolerance requirement,which verified the feasibility of the optimization method and the effectiveness of springback control measures.
作者
王欣
段磊
夏磊
张一健
赵敬怡
WANG Xin;DUAN Lei;XIA Lei;ZHANG Yi-jian;ZHAO Jing-yi(School of Mechanical Engineering,Tianjin University of Technology and Education,Tianjin 300222,China)
出处
《山东工业技术》
2022年第2期16-21,共6页
Journal of Shandong Industrial Technology
基金
天津市科技计划项目基于虚拟现实的汽车模具装配仿真系统关键技术研究及应用(项目编号:20YDTPJC01650)
天津市大学生创新创业训练计划资助项目基于数值模拟的汽车前保险杠横梁成形工艺优化(项目编号:202010066076)
天津职业技术师范大学大学生创新创业训练计划资助项目汽车左右上侧梁外板冲压成形及回弹控制研究(项目编号:202110066138)
天津市津南区科技计划项目高强钢板汽车构件多工位级进冲压精细化仿真及模具研发(项目编号:201805002)的阶段性研究成果。
关键词
高强钢板
全工序
工艺优化
回弹补偿
high strength steel plate
whole process
process optimization
springback compensation
