期刊文献+

导热型微孔透气薄膜的制备及性能研究

Preparation and properties of microporous breathable films with high thermal conductivity
下载PDF
导出
摘要 在常规透气薄膜专用料配方的基础上加入球形导热填料氧化铝,以改善透气薄膜的导热性能。用双转子连续混炼机熔融混合后,借助流延设备和拉伸单元把透气薄膜专用料制成透气薄膜,分别研究了氧化铝含量和拉伸倍率对透气薄膜性能的影响。结果表明,当线形低密度聚乙烯(PE-LLD)/碳酸钙(CaCO_(3))/氧化铝的质量比为50/35/15时,选择200%~300%之间的拉伸倍率制备的透气薄膜,在保证薄膜力学性能和透气性能的前提下,导热系数比常规透气膜提高了60%以上。 A thermally conductive Al_(2)O_(3) filler with a spherical shape was incorporated into the conventional formula of spe‑cialized materials for breathable films to improve their thermal conductance.After melt mixing with a two rotor continu‑ous mixer,the composites were used to prepare breathable films using casting equipment equipped with stretching units.The effects of Al_(2)O_(3) content and stretch ratio on the performance of breathable films were investigated.The results indi‑cated that compared to the original formula,the breathable films achieved an increase in thermal conductivity by over 60%at a mass ratio of linear low‑density polyethylene/CaCO_(3)/Al_(2)O_(3) of 50/35/15 and a stretch ratio between 200%and 300%.However,there was no influence on their mechanical properties and breathability.
作者 李果 朱惠豪 马玉录 王玉 吉华建 谢林生 LI Guo;ZHU Huihao;MA Yulu;WANG Yu;JI Huajian;XIE Linsheng(School of Mechanical and Power Engineering,East China University of Science and Technology,Shanghai 200237,China)
出处 《中国塑料》 CAS CSCD 北大核心 2022年第7期14-20,共7页 China Plastics
关键词 线形低密度聚乙烯 氧化铝 导热型透气薄膜 拉伸倍率 linear low‑density polyethylene nano‑alumina thermally conductive breathable film stretch ratio
  • 相关文献

参考文献4

二级参考文献20

  • 1汤志松,刘润静,郭奋,陈建峰,杨庆.偶联剂在纳米CaCO_3表面改性中的作用[J].北京化工大学学报(自然科学版),2004,31(4):1-4. 被引量:23
  • 2吴智华,刘志民,孟兵.填料对吹塑聚乙烯微孔薄膜性能的影响[J].工程塑料应用,2004,32(12):11-13. 被引量:6
  • 3邵鹏,曾宪通,刘述梅,赵建青,蒋文真,麦裕良.超细重质CaCO_3填充改性LLDPE/mPE薄膜的研究[J].广东化工,2007,34(6):5-8. 被引量:7
  • 4Hale W R, Dohrer K K, Tant M R, et al. A diffusion model for water vapor transmission through micropoprous polyethylene/CaCO3 films.Colloids and Surfaces A: Physicochemical and Engineering Aspects,2001,187 - 188:483.
  • 5Tishchenko G, Rosova E, Elyashevich G K, et al. Poprosity of micropoprous polyethylene membranes modified with polyp)Trole and their diffusion permeability to low-molecular weight substances. Chemical Engineering Journal,2000,79:211.
  • 6Elyashevich G K, Terlemezyan L, Kuryndin I S, et al. Thermochemical and deformational stability of micropoprous plyethlene films with polyaniline alyer. Thermochemica Acta,2001,374:23.
  • 7HALE W R,DOHRER K K,TANT M R,et al. A diffusion model for water vapor transmission through microporous polyethylene/CaCO3 films[J]. Colloid and Surface A:Physicochemical and Engineering Aspects,2001,187(1):483-491.
  • 8张文天,孙自洋,王伟. 一种高性能聚乙烯透气膜专用料及其制备方法:104530522A[P].2014-04-22.
  • 9胡华荣,李海春,陈房贵. 一种高透湿量高强度的聚烯烃透气膜及其制备方法:104558795A[P].2014-04-29.
  • 10王道登,孙建中,周其云.工艺条件对LLDPE/POE/CaCO3微孔膜的孔结构及防水透湿性能的影响[J].功能高分子学报,2008,21(1):92-95. 被引量:1

共引文献18

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部