期刊文献+

冰雹载荷下基于碳纤维增强复合材料的腔棘鱼鳞双螺旋仿生结构的撞击损伤分析 被引量:4

Analysis on Damage of Double-Helicoidal Carbon Fiber Reinforced Polymer Bionic Structure Inspired by Coelacanth Scales under Hail Load
下载PDF
导出
摘要 为了提高纤维复合材料构件抗冰雹载荷性能,基于腔棘鱼鳞独特的双螺旋结构,建立了以碳纤维增强复合材料为基体的腔棘鱼鳞双螺旋仿生结构数值模型,并验证了该仿生结构模型的有效性。对比分析了双螺旋仿生结构和正交层合结构的毁伤特性,进而探究了冰雹撞击能量及分布密度对该双螺旋仿生结构动态响应的影响。结果表明,双螺旋仿生结构在冰雹作用下的毁伤程度低于相同密度条件下的正交层合结构。当撞击能量达到1149.3 J时,正交层合结构出现了明显的基体破碎及纤维断裂,而双螺旋仿生结构仅表现为撞击区域的浅表分层并伴随少量纤维断裂。双螺旋仿生结构在冰雹撞击下的力学响应可分为3个阶段。随着撞击能量的增加,撞击区域首先发生基体拉伸,撞击点临近区域发生分层及面外凸起;进而分层区域向四周扩展,在冰雹的持续加载下撞击位置的位移达最大值;此后,仿生结构出现回弹直至稳定。该双螺旋仿生结构的能量吸收比率及接触力均随撞击能量的增加而线性增大。在相同质量冰雹的作用下,随着冰雹分布密度的增加,双螺旋仿生结构的上表面损伤程度减小,下表面损伤区域增大。研究结果为基于碳纤维增强复合材料的腔棘鱼鳞仿生结构在冰雹载荷下的轻量化设计奠定了基础。 In order to improve the impact resistance of fiber composite components under hail load,inspired by the unique double-helicoidal structure of coelacanth scales,a numerical model of the double-helicoidal bionic structure made of carbon fiber reinforced composite was established,and the effectiveness of the bionic structure model was verified.The damage characteristics of the bionic-structure and the orthogonal lamination structure under hail load were compared and analyzed,and the influences of the hail impact energy and the hail distribution on the dynamic response of the double-helicoidal bionic structure were studied.The results show that the damage degree of the double-helicoidal bionic structure under the action of hail is better than the orthogonal laminated structure of the same density.When the impact energy reaches 1149.3 J,the orthogonal laminated structure shows an obvious matrix fracture and a fiber breakage,while the double-helicoidal bionic structure only shows a superficial delamination in the impact area with a small fiber fracture.The mechanical response of the bionic structure under hail impact can be divided into three stages.As the impact energy increases,the impact area firstly shows a matrix stretching,and the area near the impact point is delaminated and bulged out-of-plane;then the delamination area expands to the surrounding area,and the displacement of the impact position reaches the maximum under the continuous load of hail;since then,the bionic structure rebounds until it is stable.Both the energy absorption ratio and the contact force of the double-helicoidal bionic structure increase linearly with the increase of the impact energy.Under the same mass hail load,the damage degree of the upper surface gradually decreases with the increase of hail distribution density,and the damage area on the lower surface gradually increases for the bionic structure.The research results lay a foundation for the lightweight design of the coelacanth scalesinspired bionic structure under hail load.
作者 韩登安 徐丹 叶仁传 任鹏 HAN Deng’an;XU Dan;YE Renchuan;REN Peng(School of Naval Architecture&Ocean Engineering,Jiangsu University of Science and Technology,Zhenjiang 212000,Jiangsu,China)
出处 《高压物理学报》 CAS CSCD 北大核心 2022年第4期164-172,共9页 Chinese Journal of High Pressure Physics
基金 国家自然科学基金(52001145)。
关键词 腔棘鱼鳞 碳纤维复合材料 双螺旋仿生结构 冰雹撞击 动态响应 毁伤 coelacanth scales carbon fiber reinforced polymer double-helicoidal bionic structure hail impact dynamic response damage
  • 相关文献

参考文献5

二级参考文献36

  • 1Singh S,Masiulaniec K C,DeWit K J,et al.Measurements of the impact forces of shed ice striking a surface[C]// Proceedings of the 32nd Aerospace Sciences Meeting and Exhibit.1994.
  • 2Lavoie M,Ensan M N,Gakwayal A.Development of an efficient numerical model for hail impact simulation based on experimental data obtained from pressure sensitive film[J].Mechanics Research Communications,2011,38(1):72-76.
  • 3Kim H,Welch D A,Kedward K T.Experimental investigation of high velocity ice impacts on woven carbon/epoxy composite panels[J].Composites Part A:Applied Science and Manufacturing,2003,34 (1):25-41.
  • 4Kim H,Kedward K T.Modeling hail ice impacts and predicting impact damage initiation in composite structures[J].AIAA Journal,2000,38(7):1278-1288.
  • 5Anghileri M,Castelletti L M L,Invernizzi F,et al.A survey of numerical models for hail impact analysis using explicit finite element codes[J].International Journal of Impact Engineering,2005,31(8):929-944.
  • 6Cartié D D R,Dell'Anno G,Partridge E P.3D reinforcement of stiffener-to-skin T-joints by Z-pinning and tufting[J].Engineering Fracture Mechanics,2006,73(16):2532-2540.
  • 7汪洋.高速冰雹撞击碳纤维增强复合材料层合板研究[D].西安:西北工业大学航空学院,2012.
  • 8Fan C,Jar P Y B,Cheng J J.Cohesive zone with continuum damage properties for simulation of delamination development in fibre composites and failure of adhesive joints[J].Engineering Fracture Mechanics,2008,75 (13):3866-3880.
  • 9黄玉松,郑威,辛培训,王玲,李宁,汪得功.贝壳珍珠层结构仿生复合材料研究[J].工程塑料应用,2008,36(10):21-25. 被引量:11
  • 10崔浩,李玉龙,刘元镛,郭嘉平,许秋莲.基于粘聚区模型的含填充区复合材料接头失效数值模拟[J].复合材料学报,2010,27(2):161-168. 被引量:20

共引文献20

同被引文献36

引证文献4

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部