期刊文献+

转炉高锰铁水炼钢工艺研究 被引量:1

Research on high manganese iron molten steelmaking process of converter
下载PDF
导出
摘要 为了解转炉高锰铁水炼钢情况,对涟钢210 t转炉42炉吹炼终点钢水进行了取样、测温,根据所得到数据计算了锰氧化反应热力学参数(K′Mn,γ(MnO),L Mn)及炉渣碱度、氧化铁、钢水温度对锰氧化热力学参数的影响。对于吹炼终点钢水与炉渣反应的平衡值及反应偏离平衡状况进行了计算。利用回归分析方法,给出了终点钢中含锰量与转炉吹炼工艺参数关系。吹炼终点渣中平均w(TFe)=20.0%,终点钢中平均w(Mn)=0.147%。终渣平均w(MnO)=6.28%,较正常含锰铁水炼钢终渣高,增加了炉渣流动性,有利于化渣。锰的收得率较低(平均23%),与转炉炼钢铁水硅含量高、渣量大有关。 In order to understand the steelmaking situation of high manganese iron in the converter,42 furnace blowing endpoint sampling and temperature measurement were conducted on the 210 t converter of Liangang.Based on the obtained data,the effect of thermodynamic parameters of manganese oxidation reaction(K′Mn,γ(MnO),L Mn),slag bisicity,iron oxide,and steel temperature on the thermodynamic parameters of manganese oxidation was calculated.The equilibrium values of the reaction between molten steel and slag at the end point of converter and the deviation from equilibrium state of the reaction were calculated.Using regression analysis method,the relationship between the manganese content in the end-point steel and the converter blowing process parameters was given.The average w(TFe)in the endpoint slag was 20.0%,and the average residual manganese mass fraction in the end-point steel was 0.147%.The average final slag w(MnO)is 6.28%,which is higher than that of normal manganese containing hot metal steelmaking,increasing the fluidity of the slag and facilitating slag melting.The yield of manganese is relatively low(average 23%),which is related to the high silicon content and large slag content in the steelmaking converter.
作者 杨文远 彭霞林 王明林 周军军 孟华栋 YANG Wenyuan;PENG Xialin;WANG Minglin;ZHOU Junjun;MENG Huadong(Metallurgical Technology Department,Central Iron and Steel Research Institute,Beijing 100081,China;Hunan Valin Lianyuan Iron and Steel Group Co.,Ltd.,Loudi 417009,China;National Engineering Research Center of Continuous Casting Technology,Central Iron and Steel Research Institute,Beijing 100081,China)
出处 《炼钢》 CAS 北大核心 2024年第1期14-18,23,共6页 Steelmaking
关键词 转炉炼钢 高锰铁水 氧化锰 锰回收率 converter steelmaking high manganese iron manganese oxide yield of manganese
  • 相关文献

参考文献5

二级参考文献19

  • 1佩尔克 邵象华(译).氧气顶吹转炉炼钢[M].北京:冶金工业出版社,1980.558.
  • 2甲斐乾.国外转炉顶底复合吹炼技术[M].北京:钢铁编辑部,1985.205.
  • 3柯玲.转炉炼钢基础[M].北京:测绘出版社,1995.12.
  • 4郝宝升.定向透气砖的研制与应用[C]//转炉复合吹炼技术.北京:《钢铁》编辑部,1986:107.
  • 5赵荣玖,李继宗.转炉复吹展现出的新趋势[C]//国外转炉顶底复合吹炼技术(三).北京:中国金属学会,1998:1.
  • 6Winker B, Chipman J. Basic Open Heath Steelmaking[M]. 3thed. New York: AIME, 1964.
  • 7Heal G A. New Look at Phosphorus Distribution[J]. Journal of the Iron and Steel Institute, 1970(7) : 664.
  • 8Gaye H. Estimation L ' equilbre Metal-laitier Basique D Acverie[J]. Congres Physico Chime en Siderurgie Versailles, 1978(10): 23.
  • 9Denier G, Barbotin J P. Development Industriel du Procede LBE[J]. Revue de Metallrugie-CIT,1981(3) :213.
  • 10Wardrop R.格里厂LBE法的操作工作[C]//国外转炉顶底复合吹炼技术(二).北京:冶金部情报所,1987.

共引文献53

同被引文献4

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部