摘要
《国家电网公司配电网工程典型设计》是低压电网的设计依据,一般电网工程的设计均需遵循典型设计的要求。在配电网架空方案的设计中,金具的计算量是最大也是最繁琐的,以典型设计为基础,提出配电架空线路工程中杆塔及金具数量计算的简便方法。此方法优化了配电网金具数量的计算过程,为项目各阶段的工程量计算提供依据。
Typical Design of Distribution Network Engineering,is the design basis of low-voltage power network,and the design of general power network engineering should follow the requirements of typical design.In the design of the overhead scheme of distribution network,the calculation amount of the metalwork is the largest and the most complicated.Discusses the simple method of calculating the number of poles and towers and metalwork in the overhead line project of distribution network based on the typical design.This method optimizes the calculation process of the quantity of the distribution network,and provides the basis for the calculation of the quantity of the project.
作者
孟宪威
王晓宇
MENG Xianwei;WANG Xiaoyu(Yichun Yuetian Electric Power Engineering Design Co.,Ltd.,State Grid Yichun Power Supply Company,Yichun 153000,China;Power Supply Service Center,State Grid Heilongjiang Electric Power Co.,Ltd.,Harbin 150000,China)
出处
《黑龙江电力》
CAS
2024年第4期325-328,334,共5页
Heilongjiang Electric Power
关键词
典型设计
配电
线路
金具数量
优化
typical design
power distribution
the line
quantity of gold fittings
optimization
