摘要
A novel method was proposed to design the structure of a bone tissue engineering scafold based on triply periodic minimal surface.In this method,reverse engineering software was used to reconstruct the surface from point cloud data.This method overcomes the limitations of commercially available software packages that prevent them from generating models with complex surfaces used for bone tissue engineering scafolds.Additionally,the fluid feld of the scafolds was simulated through a numerical method based on fnite volume and the cell proliferation performance was evaluated via an in vitro experiment.The cell proliferation and the mass flow evaluated in a bioreactor further verifed the flow feld simulated using computational fluid dynamics.The result of this study illustrates that the pressure value drops rapidly from 0.103 Pa to 0.011 Pa in the y-axis direction and the mass flow is unevenly distributed in the outlets.The mass flow in the side outlets is observed to be approximately 24.3 times higher thanthe bottom.Importantly,although the mean value of wall shear stress is signifcantly more than 0.05 Pa,there is stil a large area with a suitable shear stress below 0.05 Pa where most cells can proliferate well.The result shows that th inlet velocity 0.0075 m/s is suitable for cell proliferation in the scafold.This study provides an insight into the design analysis,and in vitro experiment of a bone tissue engineering scafold.
A novel method was proposed to design the structure of a bone tissue engineering scafold based on triply periodic minimal surface.In this method,reverse engineering software was used to reconstruct the surface from point cloud data.This method overcomes the limitations of commercially available software packages that prevent them from generating models with complex surfaces used for bone tissue engineering scafolds.Additionally,the fluid feld of the scafolds was simulated through a numerical method based on fnite volume and the cell proliferation performance was evaluated via an in vitro experiment.The cell proliferation and the mass flow evaluated in a bioreactor further verifed the flow feld simulated using computational fluid dynamics.The result of this study illustrates that the pressure value drops rapidly from 0.103 Pa to 0.011 Pa in the y-axis direction and the mass flow is unevenly distributed in the outlets.The mass flow in the side outlets is observed to be approximately 24.3 times higher thanthe bottom.Importantly,although the mean value of wall shear stress is signifcantly more than 0.05 Pa,there is stil a large area with a suitable shear stress below 0.05 Pa where most cells can proliferate well.The result shows that th inlet velocity 0.0075 m/s is suitable for cell proliferation in the scafold.This study provides an insight into the design analysis,and in vitro experiment of a bone tissue engineering scafold.
基金
Supported by National Natural Science Foundation of China(Grant Nos.51675312,51375273)
