期刊文献+

铝合金的软接触电磁连铸研究 被引量:14

Research on Soft-contact Electromagnetic Continuous Casting of Al Alloys
下载PDF
导出
摘要 采用软接触电磁连铸技术和普通连铸技术铸造了Al 4 5%Si合金,用光学显微镜分析了显微组织。结果表明:软接触连铸的内部组织细小、均匀;由于感应热的作用,频率选择不宜过高,本试验条件下1kHz为佳。 The electromagnetic casting (EMC) with soft-contact mould method was used to cast Al-4.5%Si alloy with aim to study the effect of electromagnetic field on the ingots, microstructure experimentally. Direct chill continuous casting method (DCC) was also used and investigated for comparison with the EMC with soft-contact mould method. The results show that the grain size obtained by the method of EMC with soft-contact mould is fine and uniform. Because of the influence of induced heat, the chosen excessive frequency is not suitable. Under the condition of the practice, 1kHz is the optimal technical parameter of frequency.
出处 《铸造》 CAS CSCD 北大核心 2004年第5期350-353,共4页 Foundry
基金 国家自然科学基金(No 59995442 No 50274017)资助。
关键词 电磁连铸 铝合金 显微组织 electromagnetic continuous casting Al alloys microstructure
  • 相关文献

参考文献8

二级参考文献5

共引文献22

同被引文献144

引证文献14

二级引证文献55

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部