The effect of friction stir processing(FSP)at different rotation speeds(400,630,800,and 1000 r/min)and traverse speeds(25 and 50 mm/min)on the tribological properties of a Si particle reinforced Zn−40Al−2Cu-based in-s...The effect of friction stir processing(FSP)at different rotation speeds(400,630,800,and 1000 r/min)and traverse speeds(25 and 50 mm/min)on the tribological properties of a Si particle reinforced Zn−40Al−2Cu-based in-situ composite was investigated.After preliminary optimization,800 r/min and 25 mm/min were selected as optimum FSP parameters.According to the results,multi-pass FSP improved the tribological properties.For instance,at an applied pressure of 0.75 MPa,the wear rate and average coefficient of friction(COF)of four-pass FSPed composite were lower than those of base composite by 53%and 50%,respectively.SEM examinations of worn surfaces,wear debris,and worn subsurfaces revealed that the intensive refinement and uniform distribution of microstructural phases,especially the coarse Si particles,reduced Si particles interspacing,and elimination of casting defects were the most important factors enhancing the substrate resistance against sliding-induced deformation.This led to the formation of stable tribolayers that improved the tribological properties.展开更多
文摘The effect of friction stir processing(FSP)at different rotation speeds(400,630,800,and 1000 r/min)and traverse speeds(25 and 50 mm/min)on the tribological properties of a Si particle reinforced Zn−40Al−2Cu-based in-situ composite was investigated.After preliminary optimization,800 r/min and 25 mm/min were selected as optimum FSP parameters.According to the results,multi-pass FSP improved the tribological properties.For instance,at an applied pressure of 0.75 MPa,the wear rate and average coefficient of friction(COF)of four-pass FSPed composite were lower than those of base composite by 53%and 50%,respectively.SEM examinations of worn surfaces,wear debris,and worn subsurfaces revealed that the intensive refinement and uniform distribution of microstructural phases,especially the coarse Si particles,reduced Si particles interspacing,and elimination of casting defects were the most important factors enhancing the substrate resistance against sliding-induced deformation.This led to the formation of stable tribolayers that improved the tribological properties.
