期刊文献+
共找到3篇文章
< 1 >
每页显示 20 50 100
复杂金矿物氧化焙烧-硫酸浸出-氰化法回收金银模拟计算 被引量:3
1
作者 王瑞祥 刘茶香 +4 位作者 杨裕东 袁远亮 周杰 王艳阳 徐志峰 《有色金属(冶炼部分)》 CAS 北大核心 2020年第7期69-75,共7页
基于质量守恒、化学平衡、元素分配约束、热量守恒和指标约束等原理,构建了复杂金矿物苛性钠氧化焙烧、硫酸浸出、氰化法等工序的物料平衡和热平衡多约束控制模型,开发了复杂金矿物焙烧-酸浸-氰化工艺全流程模拟系统,计算了全流程典型... 基于质量守恒、化学平衡、元素分配约束、热量守恒和指标约束等原理,构建了复杂金矿物苛性钠氧化焙烧、硫酸浸出、氰化法等工序的物料平衡和热平衡多约束控制模型,开发了复杂金矿物焙烧-酸浸-氰化工艺全流程模拟系统,计算了全流程典型工况的物质分配和能量守恒,并采用生产数据对模型进行验证。结果表明,以实际值为基准,焙烧工序中焙砂的Cu、S、Fe和SiO2含量的相对误差的百分数分别为-14.95%、-0.37%、1.77%和-6.54%;而Pb、Zn、As含量的相对误差的百分数分别为6.15%、4.94%和4.84%。酸浸分铜渣中Cu、S、Fe和SiO2含量相对误差的百分数分别为-12.90%、3.48%、5.23%和4.74%;而Pb、Zn、As含量相对误差的百分数分别为-10.75%、0和-1.27%。氰化渣中Cu、S、Zn、Fe和As含量相对误差的百分数分别为-3.57%、3.48%、5.88%、3.71%和-1.27%。 展开更多
关键词 复杂金矿物 全流程 冶金工艺流程计算平台 模拟
下载PDF
复杂金精矿-NaOH-O_(2)系热力学分析及应用
2
作者 王瑞祥 周杰 +5 位作者 刘茶香 杨裕东 李明周 袁远亮 王艳阳 徐志峰 《有色金属(冶炼部分)》 CAS 北大核心 2021年第5期67-78,共12页
从热力学理论出发,模拟计算了碱矿比、富氧浓度、残氧率、焙烧温度等因素对某含多金属复杂金精矿金、银、铜提取的影响,并通过独立反应的热力学平衡关系确定物质之间的含量关系,从而确定了复杂金精矿氢氧化钠焙烧的反应机制。结果表明,... 从热力学理论出发,模拟计算了碱矿比、富氧浓度、残氧率、焙烧温度等因素对某含多金属复杂金精矿金、银、铜提取的影响,并通过独立反应的热力学平衡关系确定物质之间的含量关系,从而确定了复杂金精矿氢氧化钠焙烧的反应机制。结果表明,焙烧最优条件为:碱矿比10%、富氧浓度25%、残氧率5%、焙烧温度630℃。通过正交试验对热力学条件进行验证,在最优条件下焙烧3h,焙砂进行硫酸浸出—氰化工序,在此条件下,金、银、铜的提取率分别为95.92%、84.24%、92.57%。 展开更多
关键词 复杂金精矿 氢氧化钠 焙烧 热力学
下载PDF
Recovery of lead and silver from zinc acid-leaching residue via a sulfation roasting and oxygen-rich chlorination leaching method 被引量:3
3
作者 WANG Rui-xiang YANG Yu-dong +5 位作者 liu cha-xiang ZHOU Jie FANG Zhuang YAN Kang TIAN Lei XU Zhi-feng 《Journal of Central South University》 SCIE EI CAS CSCD 2020年第12期3567-3580,共14页
A large amount of acid-leaching residue is produced during the conventional Zn hydrometallurgy process,and this residue has a large concentration of a variety of valuable metals.The purpose of this study was to evalua... A large amount of acid-leaching residue is produced during the conventional Zn hydrometallurgy process,and this residue has a large concentration of a variety of valuable metals.The purpose of this study was to evaluate the ability of a procedure that entails the use of sulfation roasting,water leaching,and chlorination leaching(blowing oxygen technique)to recover Pb and Ag,followed by cooling crystallization and the replacement of Ag with lead sheet,to realize the full recovery of all valuable metals from zinc acid-leaching residue;consequently,good results were achieved.The best results were obtained under the following conditions:a sulfuric acid at 70%of the raw material quality,roasting temperature of 300°C and roasting time of 2 h,followed by the process of leaching the roasted residue for 1 h by applying a water-to-solid ratio of 5꞉1 at room temperature.The recovery rates of Zn and Fe were 98.69%and 92.36%,respectively.The main parameters of the chlorine salt leaching system were as follows:Cl−concentration of 300 g/L,Fe3+concentration of 25 g/L,acid concentration of 2 mol/L,liquid-to-solid ratio of 9 mL:1 g,temperature of 90℃,and leaching time of 0.5 h;this leaching process was followed by filtration separation.These conditions resulted in high extents of leaching for Pb and Ag(i.e.,98.87%and 96.74%,respectively).Finally,the kinetics of the process of Ag leaching using Cl−ions in an oxygen-rich medium was investigated.It was found that the leaching process was controlled by the diffusion of the product layers,and the activation energy was 19.82 kJ/mol. 展开更多
关键词 acid-leaching residue sulfation roasting chlorine salt Pb Ag kinetics
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部