以LiOH溶液和不同粒径的自制球形TiO2为反应物,通过水热法快速地合成了尖晶石型结构的球形Li4Ti5O12,并考察了材料合成的水热反应机理和电化学性能。TiO2在100℃、5 mol/L Li OH溶液中经水热反应20 h得到前驱体,再经800℃热处理2 h便可...以LiOH溶液和不同粒径的自制球形TiO2为反应物,通过水热法快速地合成了尖晶石型结构的球形Li4Ti5O12,并考察了材料合成的水热反应机理和电化学性能。TiO2在100℃、5 mol/L Li OH溶液中经水热反应20 h得到前驱体,再经800℃热处理2 h便可得到粒径大小不同（0.5-1.5μm）且分布均匀的球形尖晶石Li4Ti5O12材料。Li OH在水热反应条件下扩散到球形TiO2内部,得到在分子水平混合均匀的Li-Ti-O中间体,利于高温下生成纯相的尖晶石Li4Ti5O12。所得粒径大小不同的Li4Ti5O12材料均表现出稳定的电化学循环充放电性能,其中,粒径为0.5μm的Li4Ti5O12材料的电化学性能最好：室温下,以0.2 C的倍率进行充放电,其可逆容量达到158 m Ah/g,70周后容量保持率高于99%;同时还表现出优异的高温循环稳定性,55℃下以0.2 C的倍率进行充放电,50次循环后其可逆放电比容量仍能达到125 m Ah/g。展开更多
Nanosized Li4Ti5O12 powders are synthesized by a polymerization-based method using ti- tanium butoxide and lithium nitrate as precursors and furfuryl alcohol as a polymerizable solvent. The prepared samples are charac...Nanosized Li4Ti5O12 powders are synthesized by a polymerization-based method using ti- tanium butoxide and lithium nitrate as precursors and furfuryl alcohol as a polymerizable solvent. The prepared samples are characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy and Braunauer-Emmett-Teller （BET） analysis. The electrochemical performances of these Li4Ti5O12 powders are also studied. The effect of different surfactants including citric acid, polyvinylpyrrolidone, and cetyltrimethyl ammonium bromide on the structure and properties is also investigated. It is found that pure spinel phase of Li4Ti5O12 is obtained at an annealing temperature of 700 ℃ or higher. The use of surfactants can improve the powder morphology of nanosized particles with less agglomeration. With suitable annealing temperature and the addition of surfaetant, Li4Ti5O12 powders with high BET surface area and favorable electrochemical performance can be obtained.展开更多
Li4Ti5012 (LTO) with rich R-TiO2 (17.06, 23.69, and 34.42 wt%), namely, R-TiO2@Li4Ti5O12 composites, were synthesized using the hydrothermal method and tetrabutyl titanate (TBT) as the precursor. Rietveld refinement o...Li4Ti5012 (LTO) with rich R-TiO2 (17.06, 23.69, and 34.42 wt%), namely, R-TiO2@Li4Ti5O12 composites, were synthesized using the hydrothermal method and tetrabutyl titanate (TBT) as the precursor. Rietveld refinement of X-ray diffraction (XRD) results show that the proportion of Li occupying 16d sites is extraordinary low and the lattice constants of LTO and R-TiO2 change with the ritanium dioxide content. EIS measurements showed that with in creasing R-TiO2 content, both its charge transfer impedance (Rct) and lithium ion diffusion coefficient (DLi) decreased. The changes of Rct and DLi caused by the increase of titanium dioxide content have synergic-antagonistic effects on the rate and cycle properties of Li4Ti5012. The rate performance is positively related to DLi, while the cycle property is negatively correlated with Rct, indicati ng that the rate performs nee is mainly related to DLi, while Rct more significantly affects the cycle performance. LTO-RT-17.06% exhibited excellent rate properties, especially under a high current density (5.0 C, 132.5 mAh/g) and LTO-RT-34.42% showed superior long-term cycle performance (0.012% capacity loss per cycle) compared to that of LTO-RT-17.06% and LTO-RT-23.69%.展开更多
The microstructure and performance of Li4Ti5O12 doped by Mg prepared by hydrothermal method and solid phase method were investigated. Lithium dihydrate, magnesium acetate and tetrabutyl titanate were used as the main ...The microstructure and performance of Li4Ti5O12 doped by Mg prepared by hydrothermal method and solid phase method were investigated. Lithium dihydrate, magnesium acetate and tetrabutyl titanate were used as the main raw materials. This study reveals that Mg^2+ has influences on the spherical structure, crystal development of Li4Ti5O12 and the electrochemical performances. The hollow spherical structure is composed of nano-sheet structure and the nano-sheet structure can be affected by the Mg^2+ content. For Li4-xMgxTi5 O12, the sheet structure can be refined with the increment of Mg^2+ content when x value is 0-0.1 and coarsen with the increment of Mg^2+ content when x value is 0.1-0.2. The hollow spherical Li4Ti5O12 powders prepared by hydrothermal method have better performance. The optimal Mgdoped amount of hydrothermal method is 0.1. At 0.1 C, the first discharge capacity of Li3.9Mg0.1Ti5O12 prepared through hydrothermal method at 0.1 C and 10 cycles is 182 and 178 mA hg^-1, respectively.展开更多
文摘以LiOH溶液和不同粒径的自制球形TiO2为反应物,通过水热法快速地合成了尖晶石型结构的球形Li4Ti5O12,并考察了材料合成的水热反应机理和电化学性能。TiO2在100℃、5 mol/L Li OH溶液中经水热反应20 h得到前驱体,再经800℃热处理2 h便可得到粒径大小不同（0.5-1.5μm）且分布均匀的球形尖晶石Li4Ti5O12材料。Li OH在水热反应条件下扩散到球形TiO2内部,得到在分子水平混合均匀的Li-Ti-O中间体,利于高温下生成纯相的尖晶石Li4Ti5O12。所得粒径大小不同的Li4Ti5O12材料均表现出稳定的电化学循环充放电性能,其中,粒径为0.5μm的Li4Ti5O12材料的电化学性能最好：室温下,以0.2 C的倍率进行充放电,其可逆容量达到158 m Ah/g,70周后容量保持率高于99%;同时还表现出优异的高温循环稳定性,55℃下以0.2 C的倍率进行充放电,50次循环后其可逆放电比容量仍能达到125 m Ah/g。
基金V. ACKNOWLEDGMENTS This work was supported by the National Natural Science Foundation of China （No.20971117 and No.10979049） and the Education Department of Anhui Province （No.KJ2009A142）.
文摘Nanosized Li4Ti5O12 powders are synthesized by a polymerization-based method using ti- tanium butoxide and lithium nitrate as precursors and furfuryl alcohol as a polymerizable solvent. The prepared samples are characterized by X-ray diffraction, scanning electron microscopy, transmission electron microscopy and Braunauer-Emmett-Teller （BET） analysis. The electrochemical performances of these Li4Ti5O12 powders are also studied. The effect of different surfactants including citric acid, polyvinylpyrrolidone, and cetyltrimethyl ammonium bromide on the structure and properties is also investigated. It is found that pure spinel phase of Li4Ti5O12 is obtained at an annealing temperature of 700 ℃ or higher. The use of surfactants can improve the powder morphology of nanosized particles with less agglomeration. With suitable annealing temperature and the addition of surfaetant, Li4Ti5O12 powders with high BET surface area and favorable electrochemical performance can be obtained.
基金financially supported by the National Natural Science Foundation of China(No.51641206)Shandong Natural Science Foundation Project(No.ZR2015EM013)+1 种基金Special Funds for Independent Innovation and Transformation of Achievements in Shandong Province(No.2014CGZH0911)National Key R&D Program of China(No.2016YFB0100508)
文摘Li4Ti5012 (LTO) with rich R-TiO2 (17.06, 23.69, and 34.42 wt%), namely, R-TiO2@Li4Ti5O12 composites, were synthesized using the hydrothermal method and tetrabutyl titanate (TBT) as the precursor. Rietveld refinement of X-ray diffraction (XRD) results show that the proportion of Li occupying 16d sites is extraordinary low and the lattice constants of LTO and R-TiO2 change with the ritanium dioxide content. EIS measurements showed that with in creasing R-TiO2 content, both its charge transfer impedance (Rct) and lithium ion diffusion coefficient (DLi) decreased. The changes of Rct and DLi caused by the increase of titanium dioxide content have synergic-antagonistic effects on the rate and cycle properties of Li4Ti5012. The rate performance is positively related to DLi, while the cycle property is negatively correlated with Rct, indicati ng that the rate performs nee is mainly related to DLi, while Rct more significantly affects the cycle performance. LTO-RT-17.06% exhibited excellent rate properties, especially under a high current density (5.0 C, 132.5 mAh/g) and LTO-RT-34.42% showed superior long-term cycle performance (0.012% capacity loss per cycle) compared to that of LTO-RT-17.06% and LTO-RT-23.69%.
基金Funded by the National Natural Science Foundation of China(No.51072162).
文摘The microstructure and performance of Li4Ti5O12 doped by Mg prepared by hydrothermal method and solid phase method were investigated. Lithium dihydrate, magnesium acetate and tetrabutyl titanate were used as the main raw materials. This study reveals that Mg^2+ has influences on the spherical structure, crystal development of Li4Ti5O12 and the electrochemical performances. The hollow spherical structure is composed of nano-sheet structure and the nano-sheet structure can be affected by the Mg^2+ content. For Li4-xMgxTi5 O12, the sheet structure can be refined with the increment of Mg^2+ content when x value is 0-0.1 and coarsen with the increment of Mg^2+ content when x value is 0.1-0.2. The hollow spherical Li4Ti5O12 powders prepared by hydrothermal method have better performance. The optimal Mgdoped amount of hydrothermal method is 0.1. At 0.1 C, the first discharge capacity of Li3.9Mg0.1Ti5O12 prepared through hydrothermal method at 0.1 C and 10 cycles is 182 and 178 mA hg^-1, respectively.
