To develop new type of high damping metal matrix composites, large grain size barium titanate （BaTiO3） ceramic was sintered and added into Al powder to fabricate BaTiO3/Al composites through the powder metallurgy me...To develop new type of high damping metal matrix composites, large grain size barium titanate （BaTiO3） ceramic was sintered and added into Al powder to fabricate BaTiO3/Al composites through the powder metallurgy method and hot extrusion. The damping properties of BaTiO3 ceramic, Al matrix and BaTiO3/Al composites were examined by dynamic mechanical analysis in the temperature range from 273 K to 573 K. The results show that although BaTiO3 exhibits high damping （tan δ=0.12） below 400 K, the damping capacity of 10%BaTiO3/Al （mass fraction） composites below 400 K is not increased as compared to the Al matrix. On the other hand, the damping capacity above 450 K is greatly enhanced due to the motion of dislocations at the interfaces between ceramic particles and Al matrix. The failure of exerting the intrinsic damping of BaTiO3 particles in the composites is attributed to the poor interface bonding between the particles and the matrix. The tensile strength of the composite is 42% higher than that of the Al matrix, which indicates the possibility of obtaining high strength and high damping composites via interface improvement and the addition of high volume fraction of large grain BaTiO3 particles.展开更多
The dynamic mechanical behavior of a novel polymeric composite damping material has been investigated in this article. The composite consists of chlorinated polyethylene （CPE）, N,N-dicyclohexyl-2-benzothiazolylsufen...The dynamic mechanical behavior of a novel polymeric composite damping material has been investigated in this article. The composite consists of chlorinated polyethylene （CPE）, N,N-dicyclohexyl-2-benzothiazolylsufenamide （DZ）, 4,4＇-thio-bis（3-methyl-6-tert-buthylphenol） （BPSR） and vapor-grown carbon fiber （VGCF）. It is found that either the position or the intensity of damping peak can be controlled by changing the composition of CPE/DZ/BPSR composite. Within a certain composition region, damping peak maximum depends on CPE/DZ ratio, whereas damping peak position is controlled by BPSR content. Moreover, the improvement of storage modulus can be achieved by incorporation of VGCF. These results may imply that a damping material possessing both good damping properties and high strength can be designed and obtained.展开更多
In the measurement of damping material's dynamic mechanical performance(DMP) using flexural resonating cantilever beam method,the specimen's adhesive characteristic influences the test precision and accuracy. ...In the measurement of damping material's dynamic mechanical performance(DMP) using flexural resonating cantilever beam method,the specimen's adhesive characteristic influences the test precision and accuracy. Taking its effect into account,the improved measurement equations based on the resonance method are presented. The simulated results show that,for the sake of weakening the adhesive's influence on the measured results,the adhesive should be spreaded as thin as possible when specimen is prepared,the adhesive's density and loss factor should be selected as small as possible also,and its Young's modulus should be selected according to the damping material being measured;the same adhesion condition effects differently on the test results of different damping materials,i.e. the error due to the adhesive is more inconspicuous if the damping layer has bigger thickness,modulus,loss factor and a certain density according to the damping material being measured. These conclusions provide theoretical basis for selecting adhesive,improving adhesion technology,and designing specimen.展开更多
Concerns with the nonexistence of global solutions to the initial boundary value problem for a nonlinear hyperbolic equation with material damping. Nonexitence theorems of global solutions to the above problem are pro...Concerns with the nonexistence of global solutions to the initial boundary value problem for a nonlinear hyperbolic equation with material damping. Nonexitence theorems of global solutions to the above problem are proved by the energy method, Jensen inequality and the concavity method, respectively. As applications of our main results, three examples are given.展开更多
The attenuation of technically induced surface waves is studied theoretically and experimentally. In this paper, nineteen measurements of ground vibrations induced by eight different technical sources including road a...The attenuation of technically induced surface waves is studied theoretically and experimentally. In this paper, nineteen measurements of ground vibrations induced by eight different technical sources including road and rail traffic, vibratory and impulsive construction work or pile driving, explosions, hammer impulses and mass drops are described, and it is shown that the technically induced ground vibrations exhibit a power-law attenuation v - r ~ where the exponents q are in the range of 0.5 to 2.0 and depend on the source types. Comparisons performed demonstrate that the measured exponents are considerably higher than theoretically expected. Some potential effects on ground vibration attenuation are theoretically analyzed. The most important effect is due to the material or scattering damping. Each frequency component is attenuated exponentially as exp（-kr）, but for a broad-band excitation, the sum of the exponential laws also yields a power law but with a high exponent. Additional effects are discussed, for example the dispersion of the Rayleigh wave due to soil layering, which yields an additional exponent of 0.5 in cases of impulsive loading.展开更多
This paper investigates the equilibrium of fractional derivative and 2nd derivative, which occurs if the original function is damped (damping of a power-law viscoelastic solid with viscosities η of 0 ≤ η ≤ 1), whe...This paper investigates the equilibrium of fractional derivative and 2nd derivative, which occurs if the original function is damped (damping of a power-law viscoelastic solid with viscosities η of 0 ≤ η ≤ 1), where the fractional derivative corresponds to a force applied to the solid (e.g. an impact force), and the second derivative corresponds to acceleration of the solid’s centre of mass, and therefore to the inertial force. Consequently, the equilibrium satisfies the principle of the force equilibrium. Further-more, the paper provides a new definition of under- and overdamping that is not exclusively disjunctive, i.e. not either under- or over-damped as in a linear Voigt model, but rather exhibits damping phases co-existing consecutively as time progresses, separated not by critical damping, but rather by a transition phase. The three damping phases of a power-law viscoelastic solid—underdamping, transition and overdamping—are characterized by: underdamping—centre of mass oscillation about zero line;transition—centre of mass reciprocation without crossing the zero line;overdamping—power decay. The innovation of this new definition is critical for designing non-linear visco-elastic power-law dampers and fine-tuning the ratio of under- and overdamping, considering that three phases—underdamping, transition, and overdamping—co-exist consecutively if 0 < η < 0.401;two phases—transition and overdamping—co-exist consecutively if 0.401 < η < 0.578;and one phase— overdamping—exists exclusively if 0.578 < η < 1.展开更多
By combining the advantages of effcient damping and high mechanical properties,Ni-Mn-Ga particle composites have a very good prospect for applications in damping structure design.In this paper,a ferromagnetic shape me...By combining the advantages of effcient damping and high mechanical properties,Ni-Mn-Ga particle composites have a very good prospect for applications in damping structure design.In this paper,a ferromagnetic shape memory alloy Ni-Mn-Ga composite is prepared.Ni-Mn-Ga particle/bisphenol-A epoxy composite cantilever beam vibration tests under a magnetic feld and without the magnetic feld are conducted to analyze the structural damping ratios n.Meanwhile,the damping characteristics of the Ni-Mn-Ga composite are studied through the axial loading-unloading method and the acoustic emission signals method.The damping coeffcient of the composite for different Ni-Mn-Ga volume fractions is obtained.The interface properties of the composite are discussed by micro examination and axial loading.The relationships between the damping of the composite and that of the component materials are discussed.The specifc damping capacity（SDC）and acoustic emission counts diagram of different specimens with different Ni-Mn-Ga volume fractions are analyzed.展开更多
基金Project (51001071) supported by the National Natural Science Foundation of China Projects (2012CB619400, 2012CB619600) supported by the National Basic Research Program of China+1 种基金Project (2010DFA52550) supported by the International S&T Cooperation Program of ChinaProject (20100470031) supported by China Postdoctoral Science Foundation
文摘To develop new type of high damping metal matrix composites, large grain size barium titanate （BaTiO3） ceramic was sintered and added into Al powder to fabricate BaTiO3/Al composites through the powder metallurgy method and hot extrusion. The damping properties of BaTiO3 ceramic, Al matrix and BaTiO3/Al composites were examined by dynamic mechanical analysis in the temperature range from 273 K to 573 K. The results show that although BaTiO3 exhibits high damping （tan δ=0.12） below 400 K, the damping capacity of 10%BaTiO3/Al （mass fraction） composites below 400 K is not increased as compared to the Al matrix. On the other hand, the damping capacity above 450 K is greatly enhanced due to the motion of dislocations at the interfaces between ceramic particles and Al matrix. The failure of exerting the intrinsic damping of BaTiO3 particles in the composites is attributed to the poor interface bonding between the particles and the matrix. The tensile strength of the composite is 42% higher than that of the Al matrix, which indicates the possibility of obtaining high strength and high damping composites via interface improvement and the addition of high volume fraction of large grain BaTiO3 particles.
基金supported by Zhejiang Provincial Natural Science Foundation of China(R503223)
文摘The dynamic mechanical behavior of a novel polymeric composite damping material has been investigated in this article. The composite consists of chlorinated polyethylene （CPE）, N,N-dicyclohexyl-2-benzothiazolylsufenamide （DZ）, 4,4＇-thio-bis（3-methyl-6-tert-buthylphenol） （BPSR） and vapor-grown carbon fiber （VGCF）. It is found that either the position or the intensity of damping peak can be controlled by changing the composition of CPE/DZ/BPSR composite. Within a certain composition region, damping peak maximum depends on CPE/DZ ratio, whereas damping peak position is controlled by BPSR content. Moreover, the improvement of storage modulus can be achieved by incorporation of VGCF. These results may imply that a damping material possessing both good damping properties and high strength can be designed and obtained.
基金Sponsored by the New Century Excellent Talent Project(NCET-06-0883)
文摘In the measurement of damping material's dynamic mechanical performance(DMP) using flexural resonating cantilever beam method,the specimen's adhesive characteristic influences the test precision and accuracy. Taking its effect into account,the improved measurement equations based on the resonance method are presented. The simulated results show that,for the sake of weakening the adhesive's influence on the measured results,the adhesive should be spreaded as thin as possible when specimen is prepared,the adhesive's density and loss factor should be selected as small as possible also,and its Young's modulus should be selected according to the damping material being measured;the same adhesion condition effects differently on the test results of different damping materials,i.e. the error due to the adhesive is more inconspicuous if the damping layer has bigger thickness,modulus,loss factor and a certain density according to the damping material being measured. These conclusions provide theoretical basis for selecting adhesive,improving adhesion technology,and designing specimen.
基金Project supported by the National Natural Science Foundation of China (Nos. 10371073 and 10572156) the Natural Science Foundation of Henan Province of China (No.0611050500)
文摘Concerns with the nonexistence of global solutions to the initial boundary value problem for a nonlinear hyperbolic equation with material damping. Nonexitence theorems of global solutions to the above problem are proved by the energy method, Jensen inequality and the concavity method, respectively. As applications of our main results, three examples are given.
文摘The attenuation of technically induced surface waves is studied theoretically and experimentally. In this paper, nineteen measurements of ground vibrations induced by eight different technical sources including road and rail traffic, vibratory and impulsive construction work or pile driving, explosions, hammer impulses and mass drops are described, and it is shown that the technically induced ground vibrations exhibit a power-law attenuation v - r ~ where the exponents q are in the range of 0.5 to 2.0 and depend on the source types. Comparisons performed demonstrate that the measured exponents are considerably higher than theoretically expected. Some potential effects on ground vibration attenuation are theoretically analyzed. The most important effect is due to the material or scattering damping. Each frequency component is attenuated exponentially as exp（-kr）, but for a broad-band excitation, the sum of the exponential laws also yields a power law but with a high exponent. Additional effects are discussed, for example the dispersion of the Rayleigh wave due to soil layering, which yields an additional exponent of 0.5 in cases of impulsive loading.
文摘This paper investigates the equilibrium of fractional derivative and 2nd derivative, which occurs if the original function is damped (damping of a power-law viscoelastic solid with viscosities η of 0 ≤ η ≤ 1), where the fractional derivative corresponds to a force applied to the solid (e.g. an impact force), and the second derivative corresponds to acceleration of the solid’s centre of mass, and therefore to the inertial force. Consequently, the equilibrium satisfies the principle of the force equilibrium. Further-more, the paper provides a new definition of under- and overdamping that is not exclusively disjunctive, i.e. not either under- or over-damped as in a linear Voigt model, but rather exhibits damping phases co-existing consecutively as time progresses, separated not by critical damping, but rather by a transition phase. The three damping phases of a power-law viscoelastic solid—underdamping, transition and overdamping—are characterized by: underdamping—centre of mass oscillation about zero line;transition—centre of mass reciprocation without crossing the zero line;overdamping—power decay. The innovation of this new definition is critical for designing non-linear visco-elastic power-law dampers and fine-tuning the ratio of under- and overdamping, considering that three phases—underdamping, transition, and overdamping—co-exist consecutively if 0 < η < 0.401;two phases—transition and overdamping—co-exist consecutively if 0.401 < η < 0.578;and one phase— overdamping—exists exclusively if 0.578 < η < 1.
基金supported by the National Natural Science Foundation of China (No:10972021)
文摘By combining the advantages of effcient damping and high mechanical properties,Ni-Mn-Ga particle composites have a very good prospect for applications in damping structure design.In this paper,a ferromagnetic shape memory alloy Ni-Mn-Ga composite is prepared.Ni-Mn-Ga particle/bisphenol-A epoxy composite cantilever beam vibration tests under a magnetic feld and without the magnetic feld are conducted to analyze the structural damping ratios n.Meanwhile,the damping characteristics of the Ni-Mn-Ga composite are studied through the axial loading-unloading method and the acoustic emission signals method.The damping coeffcient of the composite for different Ni-Mn-Ga volume fractions is obtained.The interface properties of the composite are discussed by micro examination and axial loading.The relationships between the damping of the composite and that of the component materials are discussed.The specifc damping capacity（SDC）and acoustic emission counts diagram of different specimens with different Ni-Mn-Ga volume fractions are analyzed.
