ZnS films were deposited on porous Si(PS) substrates with different porosities by pulsed laser deposition. The photolumi-nescence spectra of the samples were measured to study the effect of substrate porosity on lumin...ZnS films were deposited on porous Si(PS) substrates with different porosities by pulsed laser deposition. The photolumi-nescence spectra of the samples were measured to study the effect of substrate porosity on luminescence properties of ZnS/porous Si composites. After deposition of ZnS films,the red photoluminescence peak of porous Si shows a slight blueshift compared with as-prepared porous Si samples. With an increase of the porosity,a green emission at about 550 nm was observed which may be ascribed to the defect-center luminescence of ZnS films,and the photoluminescence of ZnS/porous Si composites is very close to white light. Good crystal structures of the samples were observed by x-ray diffraction,showing that ZnS films were grown in preferred orientation. Due to the roughness of porous Si surface,some cracks appear in ZnS films,which could be seen from scanning electron microscope images.展开更多
As one of the key safety problems, the motion performance and touching sea bottom of a FPSO are paid much attention by the ocean oil companies when the FPSO is exposed to survival storms in the shallow-water working a...As one of the key safety problems, the motion performance and touching sea bottom of a FPSO are paid much attention by the ocean oil companies when the FPSO is exposed to survival storms in the shallow-water working areas. In this paper, time-domain numerical simulations are carried out on a 160 kDWT FPSO with a Yoke mooring system moored in the BZ25-1 oilfield with a water depth of 16.7m. The results are compared with those of the corresponding model tests. Good agreement shows that the time-domain simulations can be used to predict the performance of the FPSO in shallow-water reasonably. It is found that the touch of seabed by a fully loaded FPSO occurred few times under survival storm conditions. Therefore, the FPSO should be less loaded than that in the fully loaded condition under the survival storms.展开更多
Through rock mechanics test, similar simulation experiment, borehole photographic observation of rock fissure, numerical simulation calculation of plastic zone distribution and deformation monitoring of rock mass duri...Through rock mechanics test, similar simulation experiment, borehole photographic observation of rock fissure, numerical simulation calculation of plastic zone distribution and deformation monitoring of rock mass during undersea mining, the fractal evolution mechanisms of rock fracture in undersea metallic deposits of Sanshandao Gold Mine were studied by fractal theory. The experimental researches on granite mechanics test in undersea deposit indicate that with the increase of load, the granite deformation energy and the fractal dimension of acoustic emission(FDAE) increase gradually. However, after reaching the peak stress of specimen, the fractal dimensions of acoustic emission(FDAEs) decrease and the granite specimen fails. Therefore, the fractal dimension evolution of rock failure can be divided into four stages, which are fissure inoculation stage, fissure growth stage, fissure expansion stage and fracture instability stage, respectively. By calculating and analyzing the damage photographs of rock specimens in Sanshandao Gold Mine, the fractal dimension of rock fissure is 1.4514, which is close to the average value of FDAE during granite destruction, i.e., 1.4693. Similar simulation experiments of undersea mining show that with the excavation proceeding, the FDAE in rock stratum increases gradually, and when the thickness of the isolation roof is less than 40 m, the FDAE begins to decrease, and meanwhile the sign of water inrush emerges. The numerical simulation researches on the plastic zone distribution of undersea mining in Sanshandao Gold Mine indicate that the fractal dimension of plastic zone(FDPZ) where the failure characteristics occur is 1.4598, close to the result of similar simulation experiment of 1.4364, which shows the sign of water inrush. Meanwhile, the thickness of the isolation roof for undersea mining should be more than 40 m, which is consistent with the results of similar simulation experiment. In Sanshandao Gold Mine, the rock fissures in undersea mining were observed by borehole photography and the rock mass deformation was monitored by multi-point displacement meters, and at the same time the fractal dimensions of strata borehole fissure distribution and energy release ratio(ERR) of rock mass were calculated by fractal principle, which are 1.2328 and 1.2685, respectively. The results demonstrate that rock deformation and fissure propagation are both in the second stage of fissure growth, and have not reached the fourth stage of fracture instability. Therefore, the conclusion can be obtained that the undersea mining in Sanshandao Gold Mine is safe at present.展开更多
In this study, a flume experiment was designed to investigate the characteristics of wave-induced pore water pressure in the soil of a silty seabed with different clay contents, soil layer buried depths and wave heigh...In this study, a flume experiment was designed to investigate the characteristics of wave-induced pore water pressure in the soil of a silty seabed with different clay contents, soil layer buried depths and wave heights respectively. The study showed that water waves propagating over silty seabed can induce significant change of pore water pressure, and the amplitude of pore pressure depends on depth of buried soil layer, clay content and wave height, which are considered as the three influencing factors for pore water pressure change. The pressure will attenuate according to exponential law with increase of soil layer buried depth, and the attenuation being more rapid in those soil layers with higher clay content and greater wave height. The pore pressure in silty seabed increases rapidly in the initial stage of wave action, then decreases gradually to a stable value, depending on the depth of buried soil layer, clay content and wave height. The peak value of pore pressure will increase if clay content or depth of buried soil layer decreases, or wave height increases. The analysis indicated that these soils with 5% clay content and waves with higher wave height produce instability in bed easier, and that the wave energy is mostly dissipated near the surface of soils and 5% clay content in soils can prevent pore pressure from dissipating immediately.展开更多
基金This work was supported by the Natural Science Foundation ofShandong Province (Grant No.Y2002A09)
文摘ZnS films were deposited on porous Si(PS) substrates with different porosities by pulsed laser deposition. The photolumi-nescence spectra of the samples were measured to study the effect of substrate porosity on luminescence properties of ZnS/porous Si composites. After deposition of ZnS films,the red photoluminescence peak of porous Si shows a slight blueshift compared with as-prepared porous Si samples. With an increase of the porosity,a green emission at about 550 nm was observed which may be ascribed to the defect-center luminescence of ZnS films,and the photoluminescence of ZnS/porous Si composites is very close to white light. Good crystal structures of the samples were observed by x-ray diffraction,showing that ZnS films were grown in preferred orientation. Due to the roughness of porous Si surface,some cracks appear in ZnS films,which could be seen from scanning electron microscope images.
基金supported by the Development Program of China(863 Program,No.2002AA602011)
文摘As one of the key safety problems, the motion performance and touching sea bottom of a FPSO are paid much attention by the ocean oil companies when the FPSO is exposed to survival storms in the shallow-water working areas. In this paper, time-domain numerical simulations are carried out on a 160 kDWT FPSO with a Yoke mooring system moored in the BZ25-1 oilfield with a water depth of 16.7m. The results are compared with those of the corresponding model tests. Good agreement shows that the time-domain simulations can be used to predict the performance of the FPSO in shallow-water reasonably. It is found that the touch of seabed by a fully loaded FPSO occurred few times under survival storm conditions. Therefore, the FPSO should be less loaded than that in the fully loaded condition under the survival storms.
基金Project(2019sdzy05)supported by the Major Scientific and Technological Innovation Project of Shandong Province,ChinaProjects(51674288,51974359)supported by the National Natural Science Foundation of China。
文摘Through rock mechanics test, similar simulation experiment, borehole photographic observation of rock fissure, numerical simulation calculation of plastic zone distribution and deformation monitoring of rock mass during undersea mining, the fractal evolution mechanisms of rock fracture in undersea metallic deposits of Sanshandao Gold Mine were studied by fractal theory. The experimental researches on granite mechanics test in undersea deposit indicate that with the increase of load, the granite deformation energy and the fractal dimension of acoustic emission(FDAE) increase gradually. However, after reaching the peak stress of specimen, the fractal dimensions of acoustic emission(FDAEs) decrease and the granite specimen fails. Therefore, the fractal dimension evolution of rock failure can be divided into four stages, which are fissure inoculation stage, fissure growth stage, fissure expansion stage and fracture instability stage, respectively. By calculating and analyzing the damage photographs of rock specimens in Sanshandao Gold Mine, the fractal dimension of rock fissure is 1.4514, which is close to the average value of FDAE during granite destruction, i.e., 1.4693. Similar simulation experiments of undersea mining show that with the excavation proceeding, the FDAE in rock stratum increases gradually, and when the thickness of the isolation roof is less than 40 m, the FDAE begins to decrease, and meanwhile the sign of water inrush emerges. The numerical simulation researches on the plastic zone distribution of undersea mining in Sanshandao Gold Mine indicate that the fractal dimension of plastic zone(FDPZ) where the failure characteristics occur is 1.4598, close to the result of similar simulation experiment of 1.4364, which shows the sign of water inrush. Meanwhile, the thickness of the isolation roof for undersea mining should be more than 40 m, which is consistent with the results of similar simulation experiment. In Sanshandao Gold Mine, the rock fissures in undersea mining were observed by borehole photography and the rock mass deformation was monitored by multi-point displacement meters, and at the same time the fractal dimensions of strata borehole fissure distribution and energy release ratio(ERR) of rock mass were calculated by fractal principle, which are 1.2328 and 1.2685, respectively. The results demonstrate that rock deformation and fissure propagation are both in the second stage of fissure growth, and have not reached the fourth stage of fracture instability. Therefore, the conclusion can be obtained that the undersea mining in Sanshandao Gold Mine is safe at present.
基金financially supported by the National Fundamental Research Program of Ministry of Science & Technology,China (Grant No. 2010CB951202)
文摘In this study, a flume experiment was designed to investigate the characteristics of wave-induced pore water pressure in the soil of a silty seabed with different clay contents, soil layer buried depths and wave heights respectively. The study showed that water waves propagating over silty seabed can induce significant change of pore water pressure, and the amplitude of pore pressure depends on depth of buried soil layer, clay content and wave height, which are considered as the three influencing factors for pore water pressure change. The pressure will attenuate according to exponential law with increase of soil layer buried depth, and the attenuation being more rapid in those soil layers with higher clay content and greater wave height. The pore pressure in silty seabed increases rapidly in the initial stage of wave action, then decreases gradually to a stable value, depending on the depth of buried soil layer, clay content and wave height. The peak value of pore pressure will increase if clay content or depth of buried soil layer decreases, or wave height increases. The analysis indicated that these soils with 5% clay content and waves with higher wave height produce instability in bed easier, and that the wave energy is mostly dissipated near the surface of soils and 5% clay content in soils can prevent pore pressure from dissipating immediately.
