The detection of hypersonic targets usually confronts range migration(RM)issue before coherent integration(CI).The traditional methods aiming at correcting RM to obtain CI mainly considers the narrow-band radar condit...The detection of hypersonic targets usually confronts range migration(RM)issue before coherent integration(CI).The traditional methods aiming at correcting RM to obtain CI mainly considers the narrow-band radar condition.However,with the increasing requirement of far-range detection,the time bandwidth product,which is corresponding to radar’s mean power,should be promoted in actual application.Thus,the echo signal generates the scale effect(SE)at large time bandwidth product situation,influencing the intra and inter pulse integration performance.To eliminate SE and correct RM,this paper proposes an effective algorithm,i.e.,scaled location rotation transform(ScLRT).The ScLRT can remove SE to obtain the matching pulse compression(PC)as well as correct RM to complete CI via the location rotation transform,being implemented by seeking the actual rotation angle.Compared to the traditional coherent detection algorithms,Sc LRT can address the SE problem to achieve better detection/estimation capabilities.At last,this paper gives several simulations to assess the viability of ScLRT.展开更多
To achieve high efficiency of nitrogen and phosphorus removal and to investigate the rule of simultaneous nitrification and denitrification phosphorus removal （SNDPR）, a whole course of SNDPR damage and recovery was...To achieve high efficiency of nitrogen and phosphorus removal and to investigate the rule of simultaneous nitrification and denitrification phosphorus removal （SNDPR）, a whole course of SNDPR damage and recovery was studied in a pilot-scale, anaerobicanoxic oxidation ditch （OD）, where the volumes of anaerobic zone, anoxic zone, and ditches zone of the OD system were 7, 21, and 280 L, respectively. The reactor was fed with municipal wastewater with a flow rate of 336 L/d. The concept of simultaneous nitrification and denitrification （SND） rate （rSND） was put forward to quantify SND. The results indicate that： （1） high nitrogen and phosphorus removal efficiencies were achieved during the stable SND phase, total nitrogen （TN） and total phosphate （TP） removal rates were 80% and 85%, respectively; （2） when the system was aerated excessively, the stability of SND was damaged, and rSND dropped from 80% to 20% or less; （3） the natural logarithm of the ratio of NOx to NH4^＋ in the effluent had a linear correlation to oxidation-reduction potential （ORP）; （4） when NO3^- was less than 6 mg/L, high phosphorus removal efficiency could be achieved; （5） denitrifying phosphorus removal （DNPR） could take place in the anaerobic-anoxic OD system. The major innovation was that the SND rate was devised and quantified.展开更多
The scaling process of calcium carbonate on a low-energy heat transfer surface－electroless plating surface was investigated in a simulated cooling water system. Owing to the very low surface energy, the electroless p...The scaling process of calcium carbonate on a low-energy heat transfer surface－electroless plating surface was investigated in a simulated cooling water system. Owing to the very low surface energy, the electroless plating surface exhibited less scaling susceptibility. A longer induction period and a lower scaling rate were obtained on the low-energy surface compared to copper surface under identical conditions. The calcite particles obtained on the electroless plating surface during the induction period were larger in size than those on copper surface because fewer crystals formed and grew at the same time on the low-energy surface. With increasing surface temperature, the induction period reduced and the scaling rate increased for the low-energy surface. When initial surface temperature was fixed, an increase in fluid velocity would reduce the induction period and increase the scaling rate due to the diffusion effect. However, when the heat flux was fixed, an increase in fluid velocity would decrease the surfacetemperature, and lead to a longer induction period and a lower scaling rate. The removal experiments of calcium carbonate scale indicated that during post induction period, the detachment was not obvious, while during the induction period, apparent removal of crystal particles was obtained on the electroless plating surface owing to the weak adhesion force. The more frequently the transient high hydrodynamic force acted, the more the detached crystal particles were.展开更多
Removal of the length ef fect in otolith shape analysis for stock identification using length scaling is an important issue; however, few studies have attempted to investigate the ef fectiveness or weakness of this me...Removal of the length ef fect in otolith shape analysis for stock identification using length scaling is an important issue; however, few studies have attempted to investigate the ef fectiveness or weakness of this methodology in application. The aim of this study was to evaluate whether commonly used size scaling methods and normalized elliptic Fourier descriptors(NEFDs) could ef fectively remove the size ef fect of fish in stock discrimination. To achieve this goal, length groups from two known geographical stocks of yellow croaker, L arimichthys polyactis, along the Chinese coast(five groups from the Changjiang River estuary of the East China Sea and three groups from the Bohai Sea) were subjected to otolith shape analysis. The results indicated that the variation of otolith shape caused by intra-stock fish length might exceed that due to inter-stock geographical separation, even when otolith shape variables are standardized with length scaling methods. This variation could easily result in misleading stock discrimination through otolith shape analysis. Therefore, conclusions about fish stock structure should be carefully drawn from otolith shape analysis because the observed discrimination may primarily be due to length ef fects, rather than dif ferences among stocks. The application of multiple methods, such as otoliths shape analysis combined with elemental fingering, tagging or genetic analysis, is recommended for sock identification.展开更多
基金supported by the National Natural Science Foundation of China(62101099)the Chinese Postdoctoral Science Foundation(2021M690558,2022T150100,2018M633352,2019T120825)+3 种基金the Young Elite Scientist Sponsorship Program(YESS20200082)the Aeronautical Science Foundation of China(2022Z017080001)the Open Foundation of Science and Technology on Electronic Information Control Laboratorythe Natural Science Foundation of Sichuan Province(2023NSFSC1386)。
文摘The detection of hypersonic targets usually confronts range migration(RM)issue before coherent integration(CI).The traditional methods aiming at correcting RM to obtain CI mainly considers the narrow-band radar condition.However,with the increasing requirement of far-range detection,the time bandwidth product,which is corresponding to radar’s mean power,should be promoted in actual application.Thus,the echo signal generates the scale effect(SE)at large time bandwidth product situation,influencing the intra and inter pulse integration performance.To eliminate SE and correct RM,this paper proposes an effective algorithm,i.e.,scaled location rotation transform(ScLRT).The ScLRT can remove SE to obtain the matching pulse compression(PC)as well as correct RM to complete CI via the location rotation transform,being implemented by seeking the actual rotation angle.Compared to the traditional coherent detection algorithms,Sc LRT can address the SE problem to achieve better detection/estimation capabilities.At last,this paper gives several simulations to assess the viability of ScLRT.
文摘To achieve high efficiency of nitrogen and phosphorus removal and to investigate the rule of simultaneous nitrification and denitrification phosphorus removal （SNDPR）, a whole course of SNDPR damage and recovery was studied in a pilot-scale, anaerobicanoxic oxidation ditch （OD）, where the volumes of anaerobic zone, anoxic zone, and ditches zone of the OD system were 7, 21, and 280 L, respectively. The reactor was fed with municipal wastewater with a flow rate of 336 L/d. The concept of simultaneous nitrification and denitrification （SND） rate （rSND） was put forward to quantify SND. The results indicate that： （1） high nitrogen and phosphorus removal efficiencies were achieved during the stable SND phase, total nitrogen （TN） and total phosphate （TP） removal rates were 80% and 85%, respectively; （2） when the system was aerated excessively, the stability of SND was damaged, and rSND dropped from 80% to 20% or less; （3） the natural logarithm of the ratio of NOx to NH4^＋ in the effluent had a linear correlation to oxidation-reduction potential （ORP）; （4） when NO3^- was less than 6 mg/L, high phosphorus removal efficiency could be achieved; （5） denitrifying phosphorus removal （DNPR） could take place in the anaerobic-anoxic OD system. The major innovation was that the SND rate was devised and quantified.
基金the National Natural Science Foundation of China (No. 29776008)
文摘The scaling process of calcium carbonate on a low-energy heat transfer surface－electroless plating surface was investigated in a simulated cooling water system. Owing to the very low surface energy, the electroless plating surface exhibited less scaling susceptibility. A longer induction period and a lower scaling rate were obtained on the low-energy surface compared to copper surface under identical conditions. The calcite particles obtained on the electroless plating surface during the induction period were larger in size than those on copper surface because fewer crystals formed and grew at the same time on the low-energy surface. With increasing surface temperature, the induction period reduced and the scaling rate increased for the low-energy surface. When initial surface temperature was fixed, an increase in fluid velocity would reduce the induction period and increase the scaling rate due to the diffusion effect. However, when the heat flux was fixed, an increase in fluid velocity would decrease the surfacetemperature, and lead to a longer induction period and a lower scaling rate. The removal experiments of calcium carbonate scale indicated that during post induction period, the detachment was not obvious, while during the induction period, apparent removal of crystal particles was obtained on the electroless plating surface owing to the weak adhesion force. The more frequently the transient high hydrodynamic force acted, the more the detached crystal particles were.
基金Supported by the National Basic Research Program of China(973 Program)(No.2015CB453302)the NSFC-Shandong Joint Fund for Marine Science Research Centre(No.U1606404)the Aoshan Science and Technology Innovation Project(No.2015ASKJ02-04)
文摘Removal of the length ef fect in otolith shape analysis for stock identification using length scaling is an important issue; however, few studies have attempted to investigate the ef fectiveness or weakness of this methodology in application. The aim of this study was to evaluate whether commonly used size scaling methods and normalized elliptic Fourier descriptors(NEFDs) could ef fectively remove the size ef fect of fish in stock discrimination. To achieve this goal, length groups from two known geographical stocks of yellow croaker, L arimichthys polyactis, along the Chinese coast(five groups from the Changjiang River estuary of the East China Sea and three groups from the Bohai Sea) were subjected to otolith shape analysis. The results indicated that the variation of otolith shape caused by intra-stock fish length might exceed that due to inter-stock geographical separation, even when otolith shape variables are standardized with length scaling methods. This variation could easily result in misleading stock discrimination through otolith shape analysis. Therefore, conclusions about fish stock structure should be carefully drawn from otolith shape analysis because the observed discrimination may primarily be due to length ef fects, rather than dif ferences among stocks. The application of multiple methods, such as otoliths shape analysis combined with elemental fingering, tagging or genetic analysis, is recommended for sock identification.
