The range accuracy of three-dimensional（3D） ghost imaging is derived. Based on the derived range accuracy equation, the relationship between the slicing number and the range accuracy is analyzed and an optimum slici...The range accuracy of three-dimensional（3D） ghost imaging is derived. Based on the derived range accuracy equation, the relationship between the slicing number and the range accuracy is analyzed and an optimum slicing number（OSN）is determined. According to the OSN, an improved 3D ghost imaging algorithm is proposed to increase the range accuracy. Experimental results indicate that the slicing number can affect the range accuracy significantly and the highest range accuracy can be achieved if the 3D ghost imaging system works with OSN.展开更多
The influence of the single photon laser altimeter range-gate width on the detection probability and ranging accuracy is discussed and analyzed,according to the LiDAR equation,single photon detection equation and the ...The influence of the single photon laser altimeter range-gate width on the detection probability and ranging accuracy is discussed and analyzed,according to the LiDAR equation,single photon detection equation and the Monte Carlo method to simulate the experiment.The simulated results show that the probability of detection is not affected by the range gate,while the probability of false alarm is relative to the gate width.When the gate width is 100 ns,the ranging accuracy can accord with the requirements of satellite laser altimeter.But when the range gate width exceeds 400 ns,ranging accuracy will decline sharply.The noise ratio will be more as long as the range gate to get larger,so the refined filtering algorithm during the data processing is important to extract the useful photons effectively.In order to ensure repeated observation of the same point for 25 times,we deduce the quantitative relation between the footprint size,footprint,and frequency repetition according to the parameters of ICESat-2.The related conclusions can provide some references for the design and the development of the domestic single photon laser altimetry satellite.展开更多
The range-velocity ambiguity caused by moving target influences on the ranging accuracy of a short-range millimeter wave radar greatly.A new method was presented in this paper to reduce the range-velocity ambiguity an...The range-velocity ambiguity caused by moving target influences on the ranging accuracy of a short-range millimeter wave radar greatly.A new method was presented in this paper to reduce the range-velocity ambiguity and improve the ranging accuracy by estimating parameters of the echo signal with fractional Fourier transform and self-correlation.And,a new quick searching algorithm was given also to increase the calculation speed.Compared to the Chinese remainder theorem method,the proposed method is excellent for its simplicity and reducing the computation complexity.The simulation results show its validity.展开更多
A gated viewing laser radar has an excellent performance in underwater low light level imaging, and it also provides a viable solution to inhibit backscattering. In this paper, a gated viewing imaging system according...A gated viewing laser radar has an excellent performance in underwater low light level imaging, and it also provides a viable solution to inhibit backscattering. In this paper, a gated viewing imaging system according to the demand for real-time imaging is presented, and then the simulation is used to analyze the performance of the real-time gated viewing system. The range accuracy performance is limited by the slice number, the width of gate, the delay time step, the initial delay time, as well as the system noise and atmospheric turbulence. The simulation results indicate that the highest range accuracy can be achieved when the system works with the optimal parameters. Finally, how to choose the optimal parameters has been researched.展开更多
Background:The suitability and performance of the bankruptcy prediction models is an empirical question.The aim of this paper is to develop a bankruptcy prediction model for Indian manufacturing companies on a sample ...Background:The suitability and performance of the bankruptcy prediction models is an empirical question.The aim of this paper is to develop a bankruptcy prediction model for Indian manufacturing companies on a sample of 208 companies consisting of an equal number of defaulted and non-defaulted firms.Out of 208 companies,130 are used for estimation sample,and 78 are holdout for model validation.The study reestimates the accounting based models such as Altman EI(Journal of Finance 23:19189-209,1968)Z-Score,Ohlson JA(Journal of Accounting Research 18:109-131,1980)Y-Score and Zmijewski ME(Journal of Accounting Research 22:59-82,1984)X-Score model.The paper compares original and re-estimated models to explore the sensitivity of these models towards the change in time periods and financial conditions.Methods:Multiple Discriminant Analysis(MDA)and Probit techniques are employed in the estimation of Z-Score and X-Score models,whereas Logit technique is employed in the estimation of Y-Score and the newly proposed models.The performance of all the original,re-estimated and new proposed models are assessed by predictive accuracy,significance of parameters,long-range accuracy,secondary sample and Receiver Operating Characteristic(ROC)tests.Results:The major findings of the study reveal that the overall predictive accuracy of all the three models improves on estimation and holdout sample when the coefficients are re-estimated.Amongst the contesting models,the new bankruptcy prediction model outperforms other models.Conclusions:The industry specific model should be developed with the new combinations of financial ratios to predict bankruptcy of the firms in a particular country.The study further suggests the coefficients of the models are sensitive to time periods and financial condition.Hence,researchers should be cautioned while choosing the models for bankruptcy prediction to recalculate the models by looking at the recent data in order to get higher predictive accuracy.展开更多
The ranging accuracy of a pseudo-noise ranging system is mainly decided by range jitter and time delay discrimination. Many factors can affect the ranging accuracy, one of which is the chip rate. In digital signal pro...The ranging accuracy of a pseudo-noise ranging system is mainly decided by range jitter and time delay discrimination. Many factors can affect the ranging accuracy, one of which is the chip rate. In digital signal processing, the time delay discrimination and autocorrelation function of sampled ranging sequences of different chip rates are very different. An approximation simulation model is established according to an in-phase quadrature (I/Q) correlator which is used to evaluate the time delay. Simulation results of the range jitter and time delay discrimination show that the chip rate which provides a non-integer sample-to-chip rate ratio can achieve a higher ranging accuracy, and some test results validate the simulation model. In some design missions, the simulation results may help to select an optimum sample-to-chip rate ratio to satisfy the design requirement on the ranging accuracy.展开更多
The accuracy of microwave ranging is mainly limited by the frequency instability of the oscillator that generates the carrier phase signal. A dual transponder carrier ranging method is used to minimize the oscillator ...The accuracy of microwave ranging is mainly limited by the frequency instability of the oscillator that generates the carrier phase signal. A dual transponder carrier ranging method is used to minimize the oscillator noise by combining the reference and the to-and-fro measurements. This ranging approach together with pseudo-noise ranging or other means can be used to measure the inter-satellite distance with a high precision. The pseudo-noise ranging system or other ranging systems help to solve the integer circles while the dual transponder ranging system guarantees the accurate fractional circle. The two satellites work in the master-slave mode. The range measurements are derived on the master satellite while the slave satellite just coherently transfers the received signal, so that the dual transponder ranging system does not need to rely on the time tagging system to synchronize the two satellites. This study first describes the dual transponder carrier ranging system and shows how the system removes most of the oscillator noise components effectively. Then, a detailed design scheme on the frequency planning of the ranging system is presented and the supporting analysis illustrates the feasibility of this system. Based on the design innovation, a laboratory demonstration system is assembled to verify the realizability of the dual transponder ranging system. The experimental results demonstrate that a high level of accuracy (about 30 μm under laboratory circumstance) can be achieved by the use of the proposed dual transponder carrier ranging system.展开更多
基金Project supported by the Young Scientist Fund of the National Natural Science Foundation of China(Grant No.61108072)
文摘The range accuracy of three-dimensional（3D） ghost imaging is derived. Based on the derived range accuracy equation, the relationship between the slicing number and the range accuracy is analyzed and an optimum slicing number（OSN）is determined. According to the OSN, an improved 3D ghost imaging algorithm is proposed to increase the range accuracy. Experimental results indicate that the slicing number can affect the range accuracy significantly and the highest range accuracy can be achieved if the 3D ghost imaging system works with OSN.
基金National Natural Science Foundation of China(No.41871382)Open Foundation of the Key Laboratory of Space Active Opto-electronics Technologyand Chinese Academy of Sciences(No.2018-ZDKF-1)。
文摘The influence of the single photon laser altimeter range-gate width on the detection probability and ranging accuracy is discussed and analyzed,according to the LiDAR equation,single photon detection equation and the Monte Carlo method to simulate the experiment.The simulated results show that the probability of detection is not affected by the range gate,while the probability of false alarm is relative to the gate width.When the gate width is 100 ns,the ranging accuracy can accord with the requirements of satellite laser altimeter.But when the range gate width exceeds 400 ns,ranging accuracy will decline sharply.The noise ratio will be more as long as the range gate to get larger,so the refined filtering algorithm during the data processing is important to extract the useful photons effectively.In order to ensure repeated observation of the same point for 25 times,we deduce the quantitative relation between the footprint size,footprint,and frequency repetition according to the parameters of ICESat-2.The related conclusions can provide some references for the design and the development of the domestic single photon laser altimetry satellite.
基金Sponsored by the NUST Research Fundation(2010ZYTS030)the Specialized Research Fundation for the Doctoral Program of Higher Education(20093219120018)
文摘The range-velocity ambiguity caused by moving target influences on the ranging accuracy of a short-range millimeter wave radar greatly.A new method was presented in this paper to reduce the range-velocity ambiguity and improve the ranging accuracy by estimating parameters of the echo signal with fractional Fourier transform and self-correlation.And,a new quick searching algorithm was given also to increase the calculation speed.Compared to the Chinese remainder theorem method,the proposed method is excellent for its simplicity and reducing the computation complexity.The simulation results show its validity.
基金supported by the Pre-research Foundation under Grant No. G020104PJ09DZ0246
文摘A gated viewing laser radar has an excellent performance in underwater low light level imaging, and it also provides a viable solution to inhibit backscattering. In this paper, a gated viewing imaging system according to the demand for real-time imaging is presented, and then the simulation is used to analyze the performance of the real-time gated viewing system. The range accuracy performance is limited by the slice number, the width of gate, the delay time step, the initial delay time, as well as the system noise and atmospheric turbulence. The simulation results indicate that the highest range accuracy can be achieved when the system works with the optimal parameters. Finally, how to choose the optimal parameters has been researched.
文摘Background:The suitability and performance of the bankruptcy prediction models is an empirical question.The aim of this paper is to develop a bankruptcy prediction model for Indian manufacturing companies on a sample of 208 companies consisting of an equal number of defaulted and non-defaulted firms.Out of 208 companies,130 are used for estimation sample,and 78 are holdout for model validation.The study reestimates the accounting based models such as Altman EI(Journal of Finance 23:19189-209,1968)Z-Score,Ohlson JA(Journal of Accounting Research 18:109-131,1980)Y-Score and Zmijewski ME(Journal of Accounting Research 22:59-82,1984)X-Score model.The paper compares original and re-estimated models to explore the sensitivity of these models towards the change in time periods and financial conditions.Methods:Multiple Discriminant Analysis(MDA)and Probit techniques are employed in the estimation of Z-Score and X-Score models,whereas Logit technique is employed in the estimation of Y-Score and the newly proposed models.The performance of all the original,re-estimated and new proposed models are assessed by predictive accuracy,significance of parameters,long-range accuracy,secondary sample and Receiver Operating Characteristic(ROC)tests.Results:The major findings of the study reveal that the overall predictive accuracy of all the three models improves on estimation and holdout sample when the coefficients are re-estimated.Amongst the contesting models,the new bankruptcy prediction model outperforms other models.Conclusions:The industry specific model should be developed with the new combinations of financial ratios to predict bankruptcy of the firms in a particular country.The study further suggests the coefficients of the models are sensitive to time periods and financial condition.Hence,researchers should be cautioned while choosing the models for bankruptcy prediction to recalculate the models by looking at the recent data in order to get higher predictive accuracy.
基金Project supported by the National Natural Science Foundation of China (No. 60904090)the Postdoctoral Science Foundation of China (No. 20080431306)the Special Postdoctoral Science Foundation of China (No. 20081458)
文摘The ranging accuracy of a pseudo-noise ranging system is mainly decided by range jitter and time delay discrimination. Many factors can affect the ranging accuracy, one of which is the chip rate. In digital signal processing, the time delay discrimination and autocorrelation function of sampled ranging sequences of different chip rates are very different. An approximation simulation model is established according to an in-phase quadrature (I/Q) correlator which is used to evaluate the time delay. Simulation results of the range jitter and time delay discrimination show that the chip rate which provides a non-integer sample-to-chip rate ratio can achieve a higher ranging accuracy, and some test results validate the simulation model. In some design missions, the simulation results may help to select an optimum sample-to-chip rate ratio to satisfy the design requirement on the ranging accuracy.
文摘The accuracy of microwave ranging is mainly limited by the frequency instability of the oscillator that generates the carrier phase signal. A dual transponder carrier ranging method is used to minimize the oscillator noise by combining the reference and the to-and-fro measurements. This ranging approach together with pseudo-noise ranging or other means can be used to measure the inter-satellite distance with a high precision. The pseudo-noise ranging system or other ranging systems help to solve the integer circles while the dual transponder ranging system guarantees the accurate fractional circle. The two satellites work in the master-slave mode. The range measurements are derived on the master satellite while the slave satellite just coherently transfers the received signal, so that the dual transponder ranging system does not need to rely on the time tagging system to synchronize the two satellites. This study first describes the dual transponder carrier ranging system and shows how the system removes most of the oscillator noise components effectively. Then, a detailed design scheme on the frequency planning of the ranging system is presented and the supporting analysis illustrates the feasibility of this system. Based on the design innovation, a laboratory demonstration system is assembled to verify the realizability of the dual transponder ranging system. The experimental results demonstrate that a high level of accuracy (about 30 μm under laboratory circumstance) can be achieved by the use of the proposed dual transponder carrier ranging system.
